2007 Volkswagen GTI Technical Service Bulletins

379 technical service bulletins (TSBs) are on record for the 2007 Volkswagen GTI. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10241340Sep 2, 2014Engine. Engine Oils Which Meet Volkswagen Oil Quality Standard VW 502 00/505 00/505 01 and VW 504 00/507 00
• 10120329Sep 2, 2014Engine. Technical Bulletin (Engine Oils Which Meet Volkswagen Oil Quality Standard): This document informs of a sample list of products generally available in the North American market that meet the Volkswagen Oil Quality Standard
• 10238565Aug 29, 2014Engine. When diagnosis on the above engine leads to the testing of the N75, please refer to the picture below. The diagram shows which vacuum ports on the N75 valve should hold vacuum and which ones should not.
• 10124481Aug 29, 2014Engine cooling. Tech Tips 92006-2014 Vehicles with 2.0T Gasoline Engine - N75 Solenoid Valve Diagnosis): When diagnosis on the above engine leads to the testing of the N75, please refer this document with graphical aid. The diagram shows which vacuum ports on the N75 valve should hold vacuum and which ones should not. Turbocharger fault codes P0299 and P0234 can be diagnosed using this test.
• 10120284Aug 29, 2014Electrical system. Quick Reference Update Guide: This document informs of the corresponding software/hardware and disc availability to the customer concerns about a vehicle
• 10241339Aug 22, 2014Engine cooling, Engine. Oil Consumption Measurement
• 10124480Aug 22, 2014Steering. Tech Tips (Electro - Steering issues): If, after replacement of the steering rack, fault code 01309 008 is set in the ABS/ESP module only, follow the test plan in GFF for Driver Steering Recommendation (DSR) or channel 3 activation. If the test plan fails to clear the fault, follow the directions in this document
• 10124479Aug 22, 2014Electrical system. Tech Tips (Comfort Module (J393) or BCM (J519) Replacement): This document informs If a comfort or body control module is replaced during normal diagnosis, make sure the factory mode has been switched OFF. This can be accomplished by selecting the test plan through GFF or through Vehicle Self Diagnosis in adaptation channel 99. Failure to deactivate factory mode will create a concern where the door locks will not…
• 10124471Aug 22, 2014Engine. Technical Bulletin (Oil Consumption Measurement): Customer states oil consumption is higher than the Volkswagen oil consumption standard of up to 0.5 quarts per 600 miles, or 0.5 liters per 1000 km. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change…
• 10242682Aug 4, 2014Electrical system. ODIS Service Update
• 10241320Jul 30, 2014Engine cooling. Update Programming to Eliminate DTC P0601 Stored in DTC Memory
• 10120237Jul 30, 2014Electrical system. Technical Bulletin (Internal Control Module Memory Check Sum Errors): This document contains Updates for the Engine Control Module using the SVM Unit code as listed in the document to address the Memory Check Sum Errors issue. The production solution for these issues is A change to ECM software was completed in the factories as of November 2006.
• 10238600Jul 4, 2014Transmission and drivetrain. Incorrect torque converter or flywheel/flexplate installation can result in transmission damage. When installing an engine, flywheel or transmission, please follow the installation procedures outlined in ELSA. For the flywheel/flexplate, please be certain the correct shim is installed between it and the crankshaft (reference VWIQ120). When installing a torque converter, press the torque converter hub through the…
• 10120207Jul 4, 2014Transmission and drivetrain. Tech Tips (Torque Converter/Flywheel/Flexplate installation): Incorrect torque converter or flywheel/flexplate installation can result in transmission damage. When installing an engine, flywheel or transmission, please follow the installation procedures outlined in ELSA. This document also contains advice on the installation of these devices
• 10238972Jun 6, 2014Tires, Wheels. The use of tire dressing gives your tires that shiny finish that completes the image of a clean (new) vehicle. There are many different tire dressing products available. When choosing a product please pay close attention to its contents. Always use a water based product.
• 10120155Jun 6, 2014Wheels, Tires. Tech Tips (All vehicles-Tire dressing for vehicle detailing): The use of tire dressing gives your tires that shiny finish that completes the image of a clean (new) vehicle. This document informs that The use of non-water based products will increase the risk of causing damage to painted surfaces. The document also gives graphical examples of the dame that can occur if non-water based products are used.
• 10253215Jun 4, 2014Exterior lighting, Other or unknown. Exterior Lights, Moisture Accumulation
• 10239592Jun 4, 2014Exterior lighting. Exterior Lights, Moisture Accumulation
• 10120169Jun 4, 2014Exterior lighting, Equipment. Technical Bulletin (Exterior Lights, Moisture Accumulation): This document informs of the Condensation and or water droplets visible on inside of exterior light lenses. The document also informs how to service the issue.
• 10238951May 30, 2014Brakes. If you have a complaint of DTCs for the low side fuel pressure being out of specification (e.g. P310B), check the fuel pressure with BOTH a mechanical gauge and by the display in Measured Value Block 103. The readings should be 1 bar higher in the MVB due to reading atmospheric pressure + fuel pressure. If the mechanical gauge reading is within specification BUT the MVB 103 reading is not 1 bar higher, check for a…
• 10124419May 30, 2014Engine. Tech Tips (2.0L FSI (BPY) Engines - Low Fuel Pressure DTCs (P310B)): This document informs on how to check fuel pressure If you have a complaint of DTCs for the low side fuel pressure being out of specification
• 10124367Apr 29, 2014Electrical system. Quick Reference Update Guide: This document informs of the corresponding software/hardware and disc availability to the customer concerns about a vehicle
• 10239534Apr 18, 2014Visibility (wipers, defrost, mirrors). HVAC, Unpleasant Odor
• 10124340Apr 18, 2014Equipment. Technical Bulletin (HVAC, Unpleasant Odor): Condensation, which is a normal condition in all A/C systems, can cause a musty odor. If the odor is noticeable in the vehicle when the engine is not turned on, the cause may be mold and mildew in the passenger compartment, and not be related to the A/C system. All other possible sources of the odor must be investigated before this document can be performed. This document…
• 10238970Apr 11, 2014Steering. If the steering rack is replaced on the above models for any reason, it is necessary to replace the steering harness as well. The new harness may be equipped with an extra connector. If all connections are made correctly, then it is necessary to remove that connector and tape the exposed wires back into the harness. Be sure to tape tightly in order to provide a water-tight repair.
• 10241266Apr 10, 2014Equipment. Squeaks, Rattles, Noise, Repair Materials
• 10124348Apr 10, 2014Equipment. Technical Bulletin (Squeaks, Rattles, Noise, Repair Materials): This doucment contains a list of components and applications developed to repair concerns of squeaks, rattles, noise and trim fit conditions.
• 10239270Apr 1, 2014Equipment. Volkswagen Warranty Policies and Procedures ? April 2014
• 10239533Mar 27, 2014Visibility (wipers, defrost, mirrors). HVAC, Unpleasant Odor
• 10124289Mar 27, 2014Equipment. Technical Bulletin (HVAC, Unpleasant Odor): Unpleasant odor is coming from Heating and Ventilation system. Odor mainly occurs after vehicle has been sitting (unused) at least 5 hours and within 20 to 60 seconds after vehicle is first started. Condensation is a normal characteristic in all A/C systems. If odor is noticeable continue to follow this document. Contaminants are effectively neutralized using the…
• 10241311Mar 26, 2014Engine cooling. Gasoline Quality
• 10124302Mar 26, 2014Engine. Technical Bulletin The use of contaminated gasoline, seasonal fuel changes (summer/winter fuel) or gasoline with a low content of deposit control additives may result in one or more of the following conditions: -Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. -Engine runs rough after cold start. -Excessive engine cranking time. -Stumbles while driving…
• 10241342Mar 25, 2014Electrical system, Engine cooling. Electric Coolant Fans Continue to Run after Ignition is OFF
• 10241310Mar 18, 2014Electrical system, Other or unknown. Software Version Management
• 10124303Mar 18, 2014Electrical system. Technical Bulletin This Technical Bulletin details the general process for carrying out a Software Version Management (SVM) software update for any Technical Bulletin (TSB) / Required Vehicle Update (RVU).
• 10241328Mar 11, 2014Engine cooling. MIL ON, DTC P0087, P1093 or P2293 Stored in ECM Fault Memory
• 10124300Mar 11, 2014Engine cooling. Technical Bulletin (Fuel Rail / System Pressure, Fuel Trim, and Fuel Pressure issues): This document informs of Excessive wear of intake camshaft lobe that drives the high pressure fuel pump. The wear limits maximum pump piston lift, causing fuel rail pressure fluctuations. The wear on the camshaft lobe can also lead to wear on the base of the high pressure fuel pump cam follower.
• 10069634Mar 11, 2014Electrical system. Summary to be provided on a future date.
• 10253214Mar 8, 2014Other or unknown, Exterior lighting. Exterior Lights, Moisture Accumulation
• 10239591Mar 6, 2014Exterior lighting. Exterior Lights, Moisture Accumulation
• 10124287Mar 6, 2014Exterior lighting. Technical Bulletin (Exterior Lights, Moisture Accumulation): Exterior light assemblies (headlights, taillights, fog lights, turn signals) are vented and may collect moisture on their inner surfaces, depending on humidity and other climatic changes. This document discusses necessary to diagnosis, and potential remedy of the issue.
• 10243008Mar 3, 2014Engine cooling, Electrical system. VW Elsa Newsletter
• 10241264Feb 25, 2014Engine cooling, Fuel system. Fuel Additive to Help Prevent Sporadic Misfire Faults
• 10239202Feb 25, 2014Other or unknown. Quick Reference Update Guide
• 10122255Feb 11, 2014Equipment. Golf/GTI Perfect Delivery Inspection (PDI) - Technician and Detailer Inspections:
• 10241265Jan 27, 2014Engine cooling, Fuel system. Fuel Additive to Help Prevent Sporadic Misfire Faults
• 10239789Jan 24, 2014Electrical system, Visibility (wipers, defrost, mirrors), Other or unknown. To detect which line(s) is inoperative, utilize a volt meter to check for 0 V, which will be present after the open in the grid line. The check must be performed with the engine running and heated rear window switched on. Switch OFF the ignition and visually locate the damage. Proceed with checking any other lines as necessary. Once the damaged line is identified, repair utilizing the Repair kit by Permatex® ITEM…
• 10122240Jan 24, 2014Visibility (wipers, defrost, mirrors). Tech Tips (Heated Rear Window, One or More Lines Inoperative): To detect which line(s) is inoperative, utilize a volt meter to check for 0 V, which will be present after the open in the grid line. This document informs of how to diagnose the issue and tips on servicing the issue
• 10243001Jan 20, 2014Steering, Engine cooling. VW Elsa Newsletter
• 10238953Nov 28, 2013Brakes, Steering, Electrical system, Fuel system, Other or unknown. If replacing the high pressure fuel pump, also remove and inspect the cam follower from the timing cover/cylinder head to inspect it for wear. If wear is found, contact the Volkswagen Dealer Technician Helpline Powertrain Team for additional instructions.

← All problems reported for the 2007 Volkswagen GTI