2014 Audi A4 Allroad Technical Service Bulletins

645 technical service bulletins (TSBs) are on record for the 2014 Audi A4 Allroad. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10122206Jan 23, 2014Electrical system, Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 13-19 dated May 23, 2013. The light bulb warning light is displayed in the instrument cluster with the ?Vehicle lights: malfunction? message. DTCs are stored in the vehicle electrical system control module. Exterior lights are functioning properly. If the headlight switch is moved to an intermediate position and remains there, the light bulb warning light and…
• 10122193Jan 21, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-64 dated January 2, 2014. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10122189Jan 21, 2014Wheels, Steering. Supersedes Technical Service Bulletin Group 44 number 13-39 dated July 12, 2013. Vehicle pulls (left or right). Steering wheel is not level or is off-center. These conditions may be noticed during PDI. If the condition is due to outside influence (such as an accident), this TSB does not apply. In an effort to gain information on this condition, Audi of America is asking you to contact the Audi Technical Assistance…
• 10122169Jan 10, 2014Electrical system. Under certain conditions, permanent mode $0A DTC codes concerning the fuel pump power stage module may remain visible after the vehicle?s OBD system has run the proper monitors successfully to allow the DTC to be erased by the system, after a proper repair. This software malfunction may cause vehicle to not pass IM inspection programs. This software update eliminates specific permanent DTC codes stored in mode $0A…
• 10067783Jan 10, 2014Electrical system. Summary to be provided on a future date.
• 10122192Jan 9, 2014Brakes, Steering, Wheels. Supersedes Technical Service Bulletin Group 46 number 12-23 dated June 18, 2012. Customer may report that the steering wheel vibrates or pulsates when the brakes are applied. Document contains the brake pulsation diagnostic guidelines.
• 10122187Jan 9, 2014Electrical system, Engine. Supersedes Technical Service Bulletin Group 20 number 13-28 dated November 14, 2013. The MIL is on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the ECM. Drivability is not affected. The NVLD pressure switch may erroneously detect a very small leak.
• 10065963Jan 9, 2014Engine. Summary to be provided on a future date.
• 10122199Jan 3, 2014Electrical system. Supersedes Technical Service Bulletin Group 91 number 11-16 dated October 5, 2011. During a Bluetooth call, the sound is difficult to hear for the other party. Voice recognition accuracy is poor. This TSB provides guidelines for testing microphones in a vehicle.
• 10122190Jan 2, 2014Brakes. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10121453Dec 17, 2013Equipment. This document contains the Audi vehicle condition checklist. This document is in Spanish.
• 10121410Dec 13, 2013Steering. The customer states that the steering feels stiff during turning. The condition occurs when the vehicle is stationary. The steering shaft needs to be updated.
• 10054863Dec 13, 2013Steering. Audi: when vehicle is stationary, the steering will feel still when turning and the steering shaft needs to be updated with improved intermediate steering shaft. Model 2009-2014 a4, a5, a5 cab, q5.
• 10121460Dec 12, 2013Tires, Equipment. This document contains the Audi normal load condition tire pressure table. This document is in Spanish.
• 10121442Dec 12, 2013Equipment. This document contains the Audi technician report checklist. All items must be completed prior to customer delivery by an Audi technician. Refer to the Special functions tab of ODIS Diagnosis using GFF for the PDI function tests. Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection. This document is in Spanish.
• 10121441Dec 12, 2013Equipment. This document contains the Audi delivery report checklist. This document is in Spanish.
• 10121411Dec 9, 2013Electrical system, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 13-96 dated October 16, 2013. Customer may report that the automatic door lock function cannot be deactivated. The "Lock when driving" (Autolock) configuration setting has been discontinued starting in some model year 2013 vehicles, and it is no longer available in the Car >> Vehicle Settings category in the MMI. The vehicle can still be unlocked while it is…
• 10121408Dec 9, 2013Wheels. Supersedes Technical Service Bulletin Group 44 number 12-32 dated August 2, 2012. Wheel bolt requires torque adjustment. Torque sticks, torque extension bars, and impact guns/wrenches are not approved by Audi of America, Inc., and should not be used to apply torque to wheel bolts. Always use a calibrated torque wrench to attain the correct wheel bolt torque and follow the proper wheel tightening procedure as…
• 10066976Dec 9, 2013Latches, locks and linkages. Summary to be provided on a future date.
• 10054859Dec 9, 2013Equipment. Audi: on certain vehicles, use calibrated torque wrench and not torque sticks, torque extension bars and impact guns/wrenches not approved for usage on wheel bolts by manufacturer, that can cause damage to brake, steering wheel, hub. Model 1995-2014 all.
• 10068730Dec 6, 2013Lane departure. Summary to be provided on a future date.
• 10121422Dec 5, 2013Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-76 dated September 23, 2013. Customer complains that Audi Side Assist is providing false warnings (no vehicle is present). Concern may or may not be duplicated. No DTCs are present in the Audi Side Assist system. This condition occurs due to an incorrect hardware set created by the supplier.
• 10121421Dec 5, 2013Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-77 dated September 23, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slow-moving stop-and-go traffic, especially on roads with multiple lanes.The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten…
• 10121409Dec 5, 2013Brakes. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
• 10068753Dec 5, 2013Lane departure. Summary to be provided on a future date.
• 10068752Dec 5, 2013Lane departure. Summary to be provided on a future date.
• 10121417Dec 3, 2013Electrical system, Equipment. GPS inaccuracies can be caused by several different factors. If it is unclear if this PSS applies, submit a Technical Assistance Center ticket for additional instruction. Perform Spec Actual and attach the GFF log to the ticket. Customer states the navigation system is not tracking the vehicle correctly. No DTCs related to the GPS antenna or MMI system are present. The issue occurs after the vehicle is parked…
• 10121407Dec 3, 2013Tires, Wheels. Supersedes Technical Service Bulletin Group 44 number 13-43 dated November 1, 2013. Steering wheel vibration and/or steering wheel oscillation at a speed range of 55 - 80 mph (88 - 128 km/h) on vehicles with very low mileage or at PDI. The condition does not result in any handling concerns or loss of vehicle control. Vehicles have original factory-installed wheels and tires.
• 10121406Dec 3, 2013Suspension, Brakes. The customer reports hearing a rattling or knocking noise when the car is driven over bumps or uneven road surfaces. The noise is noticed after the car has been driven for a while and is warmed-up, and when the temperature outside is warm. The condition can be duplicated if the brakes are applied while the car is driven over bumps. High ambient temperatures at the hydraulic guide links cause the noise.
• 10068185Dec 3, 2013Equipment. Summary to be provided on a future date.
• 10066894Dec 3, 2013Steering. Summary to be provided on a future date.
• 10121509Nov 27, 2013Electrical system. "Ignition lock faulty" message is displayed in the driver information display with the symbol shown at right. DTCs are stored in the comfort system central control unit. The "ignition lock faulty" message can be triggered by many different DTC entries. Presence of the message does not indicate that the ignition switch is faulty; the message typically has a different root cause. Replacing the ignition switch before…
• 10121506Nov 26, 2013Body and structure, Equipment. Supersedes Technical Service Bulletin Group 57 number 12-70 dated September 5, 2012. Vibration noises from the doors or the rear parcel shelf are heard, particularly when heavy bass audio is playing. Components on the doors or the parcel shelf vibrate while heavy bass audio is played.
• 10121508Nov 25, 2013Seat belts. The armrest will not operate in any direction. The height adjustment of the armrest will not engage or remain in position, or may become stuck in one position during height adjustment. If the armrest slides past its limit and the rods are pulled out of the armrest , it is because the retention of the bracket is insufficient. The armrest bracket is under tension because the guide plate has fallen loose from the…
• 10068134Nov 25, 2013Body and structure. Summary to be provided on a future date.
• 10121497Nov 21, 2013Steering, Suspension. Supersedes Technical Service Bulletin Group 44 number 13-42 dated September 27, 2013. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 - 80 mph (88 - 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10121527Nov 14, 2013Tires. This document contains the Audi normal load condition tire pressure table.
• 10121491Nov 14, 2013Electrical system. Supersedes Technical Service Bulletin Group 20 number 13-27 dated October 16, 2013. MIL on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected.
• 10121501Nov 13, 2013Suspension, Body and structure. The customer complains of hearing a creaking or knocking noise from the front of the vehicle when the vehicle is twisted, such as when being driven into or out of a driveway. The customer may describe the location of the noise source as the front suspension area. This type of noise may be caused by the contact between the hood height adjustment stop buffers and the lock carrier.
• 10066956Nov 13, 2013Body and structure. Summary to be provided on a future date.
• 10121489Nov 7, 2013Engine cooling. Supersedes Technical Service Bulletin Group 17 number 13-44 dated October 22, 2013. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine, and may change significantly over the life of the engine.
• 10121511Nov 6, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 11-25 dated November 29, 2011. The navigation DVD or other CD/DVD cannot be ejected. There are no DTCs stored in the corresponding module. The eject button is not stuck. When the eject button is pushed, the drive does not sound as if it is trying to eject the CD/DVD. Vehicles with DVD-based navigation systems now have the navigation DVD installed during…
• 10121526Nov 5, 2013Tires, Equipment. This document contains the Audi normal load condition tire pressure table.
• 10121534Nov 1, 2013Equipment. This document contains the quick reference specification book.
• 10121496Nov 1, 2013Steering. Supersedes Technical Service Bulletin Group 44 number 13-41 dated September 26, 2013. Complaints of steering wheel vibration and/or steering wheel oscillation at a speed range of 55 - 80 mph (88 - 128 km/h), on vehicles with very low mileage or at PDI. The condition does not result in any handling concerns or loss of vehicle control. Vehicles have original factory-installed wheels and tires.
• 10066893Nov 1, 2013Steering. Summary to be provided on a future date.
• 10121311Oct 29, 2013Electrical system. Supersedes Technical Service Bulletin Group 57 number 13-92 dated August 1, 2013. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle ?locked itself?. The lock command history is stored in the convenience system control module (J393).
• 10121299Oct 28, 2013Equipment. Supersedes Technical Service Bulletin Group 01 number 13-31 dated September 25, 2013. MIL on. Customer may report loss of performance. DTC P008700 (fuel rail pressure too low) may be stored in the engine control module, J623 (address word 01).
• 10065662Oct 28, 2013Fuel system. Summary to be provided on a future date.
• 10121987Oct 23, 2013Engine, Equipment. This document contains the Audi oil capacity chart.

← All problems reported for the 2014 Audi A4 Allroad