2012 Audi A5 Technical Service Bulletins

1,064 technical service bulletins (TSBs) are on record for the 2012 Audi A5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10216661Jun 17, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10212704Jun 17, 2013Transmission and drivetrain. Customer may report that the transmission does not work correctly.
• 10210651Jun 17, 2013Electrical system, Transmission and drivetrain. Software error in the transmission control module. Customer may report that the transmission does not work correctly. ? Shortly after a cold start, the following message appears in the instrument cluster display: ?Gearbox Malfunction! Journey can be continued?. The gearbox is in limp mode until the key is cycled. ? The issue is very sporadic and cannot be reproduced with a test drive. ?
• 10123588Jun 17, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-36 dated April 15, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10123579Jun 17, 2013Transmission and drivetrain. Customer may report that the transmission does not work correctly. Shortly after a cold start, the following message appears in the instrument cluster display: ?Gearbox Malfunction! Journey can be continued?. The gearbox is in limp mode until the key is cycled. The issue is very sporadic and cannot be reproduced with a test drive. DTC P17E1 (Gear positioner 2 mechanical malfunction) with DFCC 9473 is stored in the…
• 10066843Jun 17, 2013Transmission and drivetrain. Summary to be provided on a future date.
• 10052520Jun 17, 2013Transmission and drivetrain. Audi: some vehicle may experience gearbox limp mode. The issue cannot be reproduced ith a test drive, it is intermittent. Dtc p17e1 and dfcc 9473 are stored in the transmission module.
• 10212677Jun 13, 2013Engine, Electrical system, Transmission and drivetrain. Vehicle does not start or only starts when the clutch pedal is pressed very firmly
• 10123583Jun 13, 2013Electrical system. Supersedes Technical Service Bulletin Group 30 number 11-11 dated December 9, 2011. Customer may report that the vehicle does not start or only starts when the clutch pedal is pressed very firmly. The message ?Press clutch pedal to start vehicle? may appear in the instrument cluster. There may be clutch mechanism wear.
• 10123571Jun 12, 2013Brakes. Supersedes Technical Service Bulletin Group 46 number 13-42 dated June 11, 2013. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10123574Jun 11, 2013Brakes. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10123561Jun 11, 2013Electrical system, Equipment. Supersedes Technical Service Bulletin Group 87 number 12-37 dated November 16, 2012. Air conditioning is inoperative. The HVAC blower functions normally. Battery discharged; however, when charged, there is no bus silence when vehicle ignition is off. The A/C pressure/temperature sensor, G395, leaks refrigerant. This causes sensor G395 to show an incorrect or implausible value when reading MVBs.
• 10243793Jun 10, 2013Equipment. Audi Elsa Newsletter
• 10216700Jun 7, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10123586Jun 7, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-13 dated April 4, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10123564Jun 4, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 66 number 12-24 dated August 24, 2012. Customer may report the license plate attachment screws do not install properly. The license plate brackets are designed to be used with the appropriate length screw installed by hand with a screwdriver. Damaged warranty parts have been returned to Audi of America with evidence of excessive torque used when installing the screw…
• 10123562Jun 4, 2013Electrical system. Supersedes Technical Service Bulletin Group 85 number 13-15 dated March 29, 2013. The trim panel at the defroster vent on the instrument panel is deformed. The trim panel is composed of a material which expands in a moist condition. The instrument panel restricts this expansion which leads to deformation of the trim.
• 10243792Jun 3, 2013Equipment. Audi Elsa Newsletter
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10052343May 23, 2013Exterior lighting. Audi: the vehicle lights malfunction message may be displayed on the dashboard cluster. There is no failure. Also included model a4 my 2014, model a5 cabriolet my 2014, model q5 my 2014, model s7 my 2012-2014, model rs7 my 2014.
• 10212659May 22, 2013Equipment, Electrical system. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210607May 22, 2013Engine cooling. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10066812May 22, 2013Engine. Summary to be provided on a future date.
• 10212658May 15, 2013Transmission and drivetrain, Engine. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210606May 15, 2013Back-over prevention (rear camera). Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10052352May 14, 2013Latches, locks and linkages. Audi: some vehicles, in cold weather, occasionally, cannot be unlocked using the door handle touch sensor. Also inclded are model a4 my 2014, model a5 cabriolet my 2014, model q5 my 2014, model rs5 cabriolet my 2014, and model s5 cabriolet my 2011-2014.
• 10052350May 13, 2013Engine. Audi: some vehicle may experience coolant loss. The malfunction indicator lamp is on.
• 10066830May 7, 2013Steering. Summary to be provided on a future date.
• 10243992May 6, 2013Other or unknown. Elsaweb Newsletter
• 10210672May 1, 2013Equipment, Other or unknown, Electrical system. The ignition key cannot be removed even though the gear shifter is in Park (P). The vehicle is mechanically in the Park position, but this is not recognized electronically. The gear shifter cannot be moved from the Park position.
• 10210671May 1, 2013Transmission and drivetrain, Electrical system, Other or unknown. The fault occurs with ATF temperature below 60° C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10066840Apr 29, 2013Transmission and drivetrain. Summary to be provided on a future date.
• 10212698Apr 26, 2013Lane departure. Transmission warning message in cluster.
• 10123915Apr 26, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-99 dated April 1, 2013. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module (TCM), J217 (02). If DFCCs do not match exactly, this TSB does not apply. The DTCs…
• 10212697Apr 24, 2013Transmission and drivetrain. Transmission warning message in cluster
• 10210644Apr 24, 2013Electrical system, Transmission and drivetrain. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10123914Apr 24, 2013Electrical system, Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-97 dated March 4, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or "Stuck Off" is stored in transmission control module (TCM), J217 (address word 03). The fault occurs with ATF temperature below 60o…
• 10212674Apr 19, 2013Electrical system, Engine. Key does not stay or engage in ignition lock
• 10210622Apr 19, 2013Electrical system. It is possible that objects have been inserted into the ignition lock, which causes the slide of the ignition lock to become stuck in the rear part of the lock (S-contact position). The stuck slide is not allowed to return to the starting point (0-position).
• 10123929Apr 19, 2013Equipment. The fresh air blower is inoperative. DTCs may be stored in the heating and air conditioning electronics control module (address word 08). Malfunctions of the fresh air blower could be caused by a faulty printed circuit board in the fresh air blower control module and the carbon brushes bind in the brush holder and, as a consequence, lose contact with the motor commutator of the fresh air blower.
• 10123911Apr 19, 2013Equipment. Supersedes Technical Service Bulletin Group 28 number 12-19 dated May 1, 2012. The master key with remote control does not engage or stay in the ignition lock. On vehicles without Advanced Key, the remote keys are inoperable. Keyless unlocking/locking using the door handle and keyless opening of the trunk lid using the trunk handle are inoperable. The vehicle cannot be started with the Start/Stop button. The remote…
• 10228363Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10225042Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10222015Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10216657Apr 15, 2013Fuel system, Engine cooling. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.

← All problems reported for the 2012 Audi A5