2012 Audi A5 Technical Service Bulletins

1,064 technical service bulletins (TSBs) are on record for the 2012 Audi A5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10123905Apr 15, 2013Engine cooling. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10123904Apr 15, 2013Equipment, Engine. MIL on. Rough idle. DTCs are stored in the Engine Control Module (ECM), J623 (address word 01). Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are…
• 10212696Apr 9, 2013Transmission and drivetrain. Hesitation concerns, Harsh downshifts when braking or harsh 1-2 upshifts.
• 10210643Apr 9, 2013Electrical system, Transmission and drivetrain. Further transmission control module (TCM), J217, software calibration needed to improve shift concerns. Further engine control module (ECM), J623, software calibration needed to improve hesitation.
• 10123913Apr 9, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-83 dated January 31, 2013. Hesitation concerns, harsh downshifts when braking, or harsh 1-2 upshifts. Further transmission control module (TCM), J217, software calibration needed to improve shift concerns. Further engine control module (ECM), J623, software calibration needed to improve hesitation.
• 10066835Apr 9, 2013Brakes. Summary to be provided on a future date.
• 10051750Apr 9, 2013Transmission and drivetrain, Electrical system. Audi: when braking, would have harsh downshifts and hesitation concerns and also upshifts 1-2 are harsh. Calibration of software to improve shift concerns and hesitation. Models 2011-12 a4, a4 avant, a5, a5 cabriolet, q5. *pe updated 7/1/13.
• 10216699Apr 4, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10123907Apr 4, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-12 dated April 1, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10226518Apr 1, 2013Transmission and drivetrain, Lane departure. Transmission warning message in cluster.
• 10216698Apr 1, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10210668Apr 1, 2013Transmission and drivetrain, Electrical system. The DTCs are stored due to an issue with the transmission control module software. Specific DFCCs are stored as a result of the following situations: - DTC P060A00 with DFCC 8692 can be logged when a driving mode (Drive or Reverse) is selected within one second of selecting Neutral, while the vehicle rolls at a speed less than 2 mph (such as when the vehicle is being maneuvered in or out of a parking spot).
• 10123919Apr 1, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 12-77 dated December 19, 2012. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module, J217 (02). If DFCCs do not match exactly, this TSB does not apply.
• 10123906Apr 1, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-11 dated March 6, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10123901Apr 1, 2013Equipment. Supersedes Technical Service Bulletin Group 00 number 11-19 dated April 8, 2011. This TSB contains information on technician preparation when calling the Audi Technical Assistance Center
• 10123858Mar 29, 2013Equipment. The trim panel at the defroster vent on the instrument panel is deformed. The trim panel is composed of a material which expands in a moist condition. The instrument panel restricts this expansion which leads to deformation of the trim.
• 10123849Mar 29, 2013Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 09-23 dated August 12, 2009. Headlight switch knob is pressed in. The switch functions correctly. The headlight switch knob was designed with a normal position and a pushed-in position. This is a deliberate design feature designed to avoid injuries in the event of a collision.
• 10123854Mar 28, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 13-73 dated January 25, 2013. Customer complains of a "popping" noise from the radio followed by 10-15 seconds of no audio. The concern can happen in any audio source. Vehicle is equipped with MMI 3G or MMI 3G+ infotainment systems. Vehicle is not equipped with Bose or Bang & Olufsen sound systems.
• 10226464Mar 27, 2013Air bags, Lane departure. ABS warning light on - wire harness damage
• 10123861Mar 27, 2013Body and structure, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 12-80 dated November 9, 2012. The door cannot be opened from outside with the outer door handle, but it can be opened with the inner handle. The complaint is often described as follows: The customer locks the vehicle and checks by pulling the door handle whether the vehicle is locked. When opening the vehicle again, the door cannot be opened. It feels as if the…
• 10123846Mar 27, 2013Steering. Steering wheel lock does not work. Various warning lights are on. Steering feels stiffer than usual. The engine cannot be switched off. The ignition key cannot be removed. DTC with description "Brake control unit, no signal/communication" is present in several control units. DTC entry in ABS Control unit, J104 (03). One or more may be present. This condition does not result in any drivability concerns. The steering…
• 10123882Mar 25, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 11-19 dated February 10, 2011. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10123862Mar 20, 2013Body and structure, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 12-73 dated September 24, 2012. The exterior door handle touch sensors (Advanced key) are inoperative on one or several doors. The key blade can be used mechanically (driver door or trunk) or remote electrically (key remote buttons) to unlock and lock the vehicle.
• 10243990Mar 18, 2013Other or unknown. Elsaweb Newsletter
• 10066872Mar 18, 2013Transmission and drivetrain. Summary to be provided on a future date.
• 10228350Mar 7, 2013Engine cooling. Engine warning light on after engine replacement
• 10225029Mar 7, 2013Engine cooling. Engine warning light on after engine replacement
• 10222002Mar 7, 2013Engine cooling. Engine warning light on after engine replacement
• 10123896Mar 7, 2013Engine cooling. The engine warning light is on after engine replacement. The engine is not running roughly. However, the engine control module, J623 (01), is storing one or more of the following engine misfire fault codes: DTCs P0300 - P0304. The fault codes occur at light load, between 8% and 14% accelerator pedal position. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
• 10226516Mar 4, 2013Electrical system, Transmission and drivetrain. Transmission warning message in cluster, P074100 stored in TCM
• 10210666Mar 4, 2013Other or unknown, Transmission and drivetrain. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10123878Mar 4, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-86 dated February 6, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or "Stuck Off" is stored in transmission control module, J217 (03). The fault occurs with ATF temperature below 60o C.
• 10123863Mar 4, 2013Electrical system, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 13-82 dated February 5, 2013. Central locking via remote control does not work either sporadically or permanently. The locks can still be operated manually. Missing synchronization between the remote control key and vehicle because the battery has been disconnected or the battery of the remote control has been replaced.
• 10251023Feb 18, 2013Suspension. Steering wheel shimmy, vibration and/or oscillation
• 10250475Feb 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10123987Feb 18, 2013Suspension. Supersedes Technical Service Bulletin Group 44 number 13-35 dated January 18, 2013. Customer feels vibration from 55 - 80 mph (88 - 128 km/h) in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not result in any handling concerns or loss of vehicle control.
• 10124007Feb 14, 2013Electrical system, Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 12-79 dated June 6, 2012. Light bulb warning light and the message Vehicle lights: malfunction is displayed in the instrument cluster display. DTC 03280 (Light switch position implausible signal) is stored in the vehicle electrical system control module, J519 (09). Exterior lights are functioning properly.
• 10250459Feb 6, 2013Transmission and drivetrain. Transmission warning message in cluster, P074100 stored in TCM
• 10123975Feb 6, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-85 dated February 4, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 "Torque Converter Clutch Circuit Performance" or "Stuck Off" is stored in TCM. The fault occurs with ATF temperature below 60o C. Check for this temp range in the extended…
• 10124000Feb 5, 2013Back-over prevention (rear camera). Supersedes Technical Service Bulletin Group 91 number 12-61 dated October 1, 2012. Parking aid sporadically warns of obstacles when none exist. Parking aid is inoperative or provides constant warning. Various parking aid sensor fitting issues. Environmental conditions.
• 10123995Feb 5, 2013Equipment, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 11-55 dated August 22, 2011. Central locking via remote control does not work either sporadically or permanently. The locks can still be operated manually. Missing synchronization between the remote control key and vehicle because the battery has been disconnected or the battery of the remote control has been replaced.
• 10250458Feb 4, 2013Transmission and drivetrain. Transmission warning message in cluster, P074100 stored in TCM
• 10123974Feb 4, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-80 dated January 16, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 "Torque Converter Clutch Circuit Performance" or "Stuck Off" is stored in TCM. The fault occurs with ATF temperature below 60o C. Check for this temp range in the extended…
• 10226513Jan 31, 2013Engine cooling, Other or unknown, Transmission and drivetrain. Hesitation concerns, Harsh downshifts when braking or harsh 1-2 upshifts.
• 10210663Jan 31, 2013Other or unknown, Engine cooling, Transmission and drivetrain. Further TCM software calibration to improve shift concerns. Further ECM software calibration to improve hesitation. Hesitation concerns, Harsh downshifts when braking or harsh 1-2 upshifts.
• 10066854Jan 31, 2013Transmission and drivetrain. Summary to be provided on a future date.
• 10251018Jan 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10226510Jan 16, 2013Transmission and drivetrain, Lane departure. Transmission warning message in cluster, P074100 stored in TCM
• 10210660Jan 16, 2013Transmission and drivetrain. DTC P074100 Torque Converter Clutch Circuit Performance or Stuck Off is stored in TCM. Customer may report transmission warning lamp illuminated in instrument cluster.
• 10210625Jan 13, 2013Electrical system, Transmission and drivetrain. There may be clutch mechanism wear. Customer may report that the vehicle does not start or only starts when the clutch pedal is pressed very firmly. The message ?Press clutch pedal to start vehicle? may appear in the instrument cluster.

← All problems reported for the 2012 Audi A5