2014 Audi A5 Technical Service Bulletins

1,085 technical service bulletins (TSBs) are on record for the 2014 Audi A5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10119982Apr 16, 2015Equipment. Supersedes Technical Service Bulletin Group 00 number 13-54 dated October 10, 2013. Audi of America (in conjunction with AUDI AG) is conducting a pilot program in the USA with a limited number of specially-built vehicles. These vehicles have a persistent internet connection and are designed to be accessed and started without the need for a traditional remote key. Instead, these vehicles use NFC (Near-field…
• 10119999Apr 7, 2015Seats. Supersedes Technical Service Bulletin Group 74 number 14-19 dated May 9, 2014. The panel on the back of the front seat is warped or dented. The headrest on the rear seatback may also be damaged. The damaged is caused when the headrest of the rear seat backrest comes in contact with the back of the front seat. This occurs when the rear seat is folded down with the headrests installed, and the front seat is moved…
• 10119962Mar 27, 2015Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-79 dated December 5, 2013. Audi side assist deactivates or is sporadically inoperative when the vehicle is driven in slow-moving stop-and-go traffic, especially on roads with multiple lanes. The message "Audi side assist unavailable: Sensors blocked" appears in the driver information panel. The system can be activated approximately ten minutes after the…
• 10119960Mar 25, 2015Electrical system, Lane departure. Supersedes Technical Service Bulletin Group 96 number 14-88 dated November 25, 2014. Customer may report that Audi side assist is providing false warnings (no vehicle is present in the blind spot). No faults related to Audi side assist are stored. This TSB does not refer to warning messages on the instrument cluster. It applies only to false displays of the warning lights in the door mirrors. Incorrect software…
• 10120679Mar 24, 2015Equipment. Supersedes Technical Service Bulletin Group 66 number 15-46 dated February 19, 2015. Customer may report that the license plate attachment screws do not install properly. The license plate brackets are designed to be used with the appropriate-length screw installed by hand with a screwdriver. Damaged warranty parts have been returned to Audi of America with evidence of excessive torque used when installing the…
• 10119947Mar 23, 2015Steering. Supersedes Technical Service Bulletin Group 48 number 14-57 dated January 29, 2014. Customer may report hearing creaking or squeaking noise from the steering column when steering slowly (the noise can be duplicated while the vehicle is stationary if the steering wheel is turned slowly). The noise may get louder at higher temperatures or when the vehicle is driven for a longer period of time. The noise comes from…
• 10119957Mar 20, 2015Equipment. Supersedes Technical Service Bulletin Group 91 number 14-27 dated March 4, 2014. The addresses and contacts stored in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus disappear intermittently. Intermittently, the MMI system does not appear to remember that the user's myAudi PIN has already been entered, and it requires the user to enter the PIN again. The voice…
• 10119956Mar 20, 2015Electrical system. Supersedes Technical Service Bulletin Group 91 number 14-69 dated November 4, 2014. The following message appears on the MMI display: "Device or cable type not supported". The AMI cable being used is a genuine Audi-branded cable with an Audi part number (see Required Parts and Tools for a list of valid part numbers). The "Device or cable type not supported" message may be displayed when an incorrect AMI cable type…
• 10119945Mar 17, 2015Engine cooling. Supersedes Technical Service Bulletin Group 10 number 13-10 dated September 5, 2013. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust…
• 10120675Mar 12, 2015Engine cooling. Customer states that engine overheats. No MIL. No related DTCs are stored. Various parts have been replaced under warranty for the condition noted above, but no issues were identified with these parts. In an effort to gain information on the overheat condition for the vehicles listed above, we are asking that you contact the Audi Technical Assistance Center (TAC) before replacing any parts. This will assist us in…
• 10119955Mar 10, 2015Equipment. Supersedes Technical Service Bulletin Group 91 number 08-129 dated November 12, 2008. Customer states that the reception of satellite radio occasionally fades or drops out. The information display may show a message related to the satellite radio, such as "Linking", "Updating", "Acquiring Signal", "Loading", "No Signal", or "No Sat".
• 10119940Mar 9, 2015Fuel system. Supersedes Technical Service Bulletin Group 01 number 13-09 dated June 21, 2013. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in excessive accumulation of deposits on intake valves, intake manifold, fuel injectors, and combustion chambers, engine running rough after cold start, excessive engine cranking time, hesitations while driving, rough engine idle…
• 10119946Mar 6, 2015Engine cooling. Supersedes Technical Service Bulletin Group 17 number 13-35 dated January 9, 2013. This bulletin lists engine oils that meet Audi oil quality standards (VW 501 01, 502 00, 505 00, 505 01, and 504 00/507 00).
• 10119958Mar 4, 2015Electrical system. Supersedes Technical Service Bulletin Group 94 number 15-60 dated February 12, 2015. The light bulb warning light is displayed in the instrument cluster with the following message: "Vehicle lights: malfunction". DTCs are stored in the vehicle electrical system control module. Exterior lights are functioning properly.
• 10120672Mar 3, 2015Engine, Transmission and drivetrain. Rattling noises are heard from the timing chain drive for about 1-3 seconds after the first engine start of the day. The noises are caused by one of the upper chain tensioners. The noises do not lead to damage. Improved chain tensioner.
• 10120699Feb 19, 2015Brakes. Supersedes Technical Service Bulletin Group 46 number 14-94 dated August 11, 2014. The brake pad wear indicator comes on, but brake pad thickness is above the wear limit.
• 10120684Feb 17, 2015Electrical system, Transmission and drivetrain. Supersedes Technical Service Bulletin Group 01 number 14-78 dated May 28, 2014. MIL is on due to DTC P013E00 being stored in the ECM. ECM software needs to be updated.
• 10120682Feb 13, 2015Engine cooling. Supersedes Technical Service Bulletin Group 01 number 13-69 dated February 14, 2013. Noises and inconsistent engine operation after cold start during the catalyst heating phase. The customer may misinterpret these symptoms as engine misfiring. This bulletin applies only to non-diesel engines.
• 10120705Feb 12, 2015Exterior lighting, Electrical system. Supersedes Technical Service Bulletin Group 94 number 14-32 dated January 23, 2014. The light bulb warning light is displayed in the instrument cluster with the following message: "Vehicle lights: malfunction". DTCs are stored in the vehicle electrical system control module. Exterior lights are functioning properly.
• 10120696Feb 9, 2015Brakes. Supersedes Technical Service Bulletin Group 46 number 15-00 dated January 23, 2015. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
• 10120671Jan 23, 2015Brakes. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Brake noise can be attributed to many causes. Aftermarket pads or discs have been installed. There is debris (such as small stones, grit, road salt, or sand) between brake disc and brake pad. Discs are covered with rust. Rust can form when the…
• 10119863Jan 21, 2015Equipment. Paint flakes off radiator grille or license plate holder. The surfaces of these components were too smooth (due to high-gloss polishing tools), which led to weak adhesion of the paint during production. Only components with color index T94 are affected.
• 10119865Jan 20, 2015Equipment. The vehicle horn sounds abnormal or is inoperative. Various parts have been replaced under warranty for the condition noted above, but no issues were identified with these parts. Contact the Audi Technical Assistance Center (TAC) before replacing any parts. No changes to production have been made, as no issue has been identified.
• 10119861Jan 15, 2015Brakes. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Brake noise can be attributed to many causes. Brake discs or brake pads are close to or below their wear limit. Aftermarket pads or discs have been installed. There is debris (such as small stones, grit, road salt, or sand) between brake disc…
• 10231116Dec 22, 2014Equipment. Product quality is Announcing a new innovation in technical service bulletins: portable, easy to access videos
• 10230501Dec 19, 2014Electrical system. EVAP System Leak Detected NVLD very small leak
• 10225088Dec 19, 2014Engine cooling. System Leak Detected.
• 10124893Dec 19, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 13-74 dated February 5, 2013. Parking aid sporadically warns of obstacles when none exist. Parking aid is inoperative or provides constant warning. Various parking aid sensor fitting issues. Environmental conditions.
• 10065974Dec 19, 2014Engine. Summary to be provided on a future date.
• 10250945Dec 10, 2014Suspension. Rattle noise from rear suspension
• 10250674Dec 10, 2014Suspension. Rattle noise from rear suspension
• 10228302Dec 10, 2014Equipment. High quality media files (video and sound) are now integrated into technical service bulletins on a case-by-case basis. Media files can now be viewed on any smartphone or tablet.
• 10224981Dec 10, 2014Electrical system, Equipment. High quality media files (video and sound) are now integrated into technical service bulletins on a case-by-case basis. Media files can now be viewed on any smartphone or tablet.
• 10221954Dec 10, 2014Equipment. High quality media files (video and sound) are now integrated into technical service bulletins on a case-by-case basis. Media files can now be viewed on any smartphone or tablet.
• 10124887Dec 10, 2014Body and structure. Clunking or rattling noises are heard from rear suspension area when vehicle is driven over bumps. These noises can be caused by an improperly seated rear bump stop (which occurs when the rear bump stop was not fully inserted into the rear shock absorber mounting during PDI).
• 10124882Dec 10, 2014Electrical system. High quality media files (video and sound) are now integrated into technical service bulletins on a case-by-case basis. Media files can now be viewed on any smartphone or tablet. Audi of America has started to host its TSB videos outside of ElsaPro. Doing so provides higher-quality videos, more reliable access to the videos, and the ability to view the videos on different devices.
• 10066028Dec 10, 2014Suspension. Summary to be provided on a future date.
• 10250944Dec 8, 2014Steering. Steering wheel shimmy, vibration, and/or oscillation
• 10124892Dec 8, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 12-63 dated October 4, 2012. The customer may report flickering of the dash insert lighting, of the A/C control panel lighting, or of the inside light. The condition occurs when the accelerator is pressed while the vehicle is in P or N, or when the vehicle is shifted down when moving downhill. Only vehicles with PR number 8GH may be affected.
• 10124888Dec 8, 2014Equipment. Supersedes Technical Service Bulletin Group 44 number 14-50 dated May 14, 2014. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. Customer feels the vibration while driving at highway speeds from 55 ? 80 mph (88 ? 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10124898Dec 4, 2014Equipment. This is an advance notice for Audi of America employees. This notice contains information for the accessories operations technical bulletin.
• 10231113Dec 1, 2014Engine cooling. Wastegate linkage dissconnected
• 10216706Nov 26, 2014Steering, Transmission and drivetrain. The circlip connecting the turbo wastegate actuator rod and the wastegate flap lever can fall of due to low tension of the clip. Consequently, the wastegate linkage becomes disconnected, causing MIL on and DTC P029900.
• 10124870Nov 26, 2014Engine. Supersedes Technical Service Bulletin Group 21 number 14-20 dated November 17, 2014. MIL on. Customer may report a reduction in power. DTC P029900 (Turbo/Super Charger Underboost) is stored in the engine control module (ECM), J623 (address word 01). The circlip connecting the turbo wastegate actuator rod and the wastegate flap lever can fall of due to low tension of the clip. Consequently, the wastegate linkage…
• 10065978Nov 26, 2014Electrical system. Summary to be provided on a future date.
• 10231143Nov 24, 2014Equipment. Technical bulletins and updates
• 10067706Nov 24, 2014Equipment. Summary to be provided on a future date.
• 10216674Nov 18, 2014Engine cooling, Fuel system. A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
• 10124868Nov 18, 2014Engine cooling. A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
• 10231142Nov 17, 2014Equipment. Technical bulletins and updates

← All problems reported for the 2014 Audi A5