2013 Audi A7 Technical Service Bulletins

1,450 technical service bulletins (TSBs) are on record for the 2013 Audi A7. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10250664Jul 2, 2014Steering. Squeaking noises when steering or maneuvering
• 10122540Jul 2, 2014Suspension. Supersedes Technical Service Bulletin Group 40 number 13-34 dated September 23, 2013. Oil appears on one or several shock absorbers.
• 10122539Jul 2, 2014Steering. Supersedes Technical Service Bulletin Group 40 number 13-35 dated September 23, 2013. Squeaking noises are heard when the steering wheel is turned or maneuvered. The noises may be more prevalent in wet weather. The folds of the outer rubber boots on the front axle shafts may come in contact with each other when the steering wheel is turned, causing squeaking noises. These noises are more likely to occur when the…
• 10226533Jul 1, 2014Transmission and drivetrain. Transmission warning message in cluster.
• 10226532Jul 1, 2014Transmission and drivetrain. Harsh downshifts when braking or harsh 1-2 upshift under acceleration
• 10210683Jul 1, 2014Electrical system, Transmission and drivetrain, Other or unknown. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10210682Jul 1, 2014Transmission and drivetrain, Electrical system, Engine. Further transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
• 10122534Jul 1, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 14-22 dated May 1, 2014. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or ?Stuck Off? is stored in transmission control module (TCM). The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended…
• 10122533Jul 1, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-96 dated March 4, 2013. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration. Further transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
• 10231130Jun 30, 2014Engine cooling. Idenifying and mixing factory fill engine coolants
• 10216685Jun 26, 2014Engine cooling. The NVLD pressure switch may erroneously detect a very small leak.
• 10122416Jun 26, 2014Engine cooling, Equipment. Supersedes Technical Service Bulletin Group 20 number 14-32 dated March 21, 2014. The MIL is on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected. The NVLD pressure switch may erroneously detect a very small leak.
• 10122415Jun 20, 2014Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-41 dated June 20, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10231128Jun 16, 2014Equipment. Technical bulletins and updates
• 10231127Jun 9, 2014Equipment, Electrical system. ElsaPro Software update and technical bulletins
• 10122421Jun 2, 2014Seats, Equipment. Supersedes Technical Service Bulletin Group 74 number 14-17 dated February 21, 2014. Customer may complain that the seat pneumatics (side bolsters and lumbar support) actuate without any input from the customer. This condition can occur when the vehicle is driven at high altitudes or when the outside temperature fluctuates.
• 10066351Jun 2, 2014Seats, Electrical system. Summary to be provided on a future date.
• 10212703May 29, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10122455May 29, 2014Electrical system. Supersedes Technical Service Bulletin Group 01 number 13-42 dated November 21, 2013. DTC P164D00 is stored in the engine control module. Red oil pressure warning light may be on. An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be reduced.
• 10065431May 29, 2014Fuel system. Summary to be provided on a future date.
• 10228295May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10226529May 28, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10224974May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10221947May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10210679May 28, 2014Electronic stability control, Transmission and drivetrain. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system…
• 10122465May 28, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-07 dated May 29, 2013. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off). No DTCs are stored. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left…
• 10122452May 28, 2014Engine, Equipment. Supersedes Technical Service Bulletin Group 00 number 13-49 dated May 14, 2013. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating…
• 10231139May 26, 2014Equipment. Technical bulletins and updates
• 10226528May 22, 2014Transmission and drivetrain. Transmission warning message in cluster.
• 10210678May 22, 2014Engine cooling, Electrical system, Transmission and drivetrain. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. The DTCs are stored due to an issue with the transmission control module software.
• 10122464May 22, 2014Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-17 dated September 11, 2013. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module (TCM). If DFCCs do not match exactly, this TSB does not apply. The DTCs are…
• 10065997May 22, 2014Electrical system. Summary to be provided on a future date.
• 10216614May 21, 2014Back-over prevention (rear camera). The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the condition. Improved software for the comfort system central control module, J393 (address word 46) in production. Service software update will follow at a later date (to be determined).
• 10122454May 21, 2014Electrical system. Supersedes Technical Service Bulletin Group 01 number 14-51 dated January 3, 2014. The customer complains that the vehicle sporadically cannot be started. The yellow gearbox warning light may be illuminated. DTCs may be present. The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the condition.
• 10065429May 21, 2014Electrical system. Summary to be provided on a future date.
• 10250971May 14, 2014Steering. Steering wheel shimmy, vibration, and/or oscillation
• 10122467May 14, 2014Suspension, Steering. Supersedes Technical Service Bulletin Group 44 number 14-49 dated April 17, 2014. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 ? 80 mph (88 ? 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10249085May 13, 2014Other or unknown. Google Maps Street View (NVLW))
• 10122472May 2, 2014Electrical system. Supersedes Technical Service Bulletin Group 64 number 12-22 dated July 5, 2012. After one or both of the front door control units (J386/J387) is replaced, one or both of the rear door control units (J3888/J389) cannot be coded or parameterized via an SVM specified vs. actual comparison (spec/actual). The parameter data in the software coding container has changed for the front and rear door control units.
• 10226521May 1, 2014Transmission and drivetrain, Electrical system, Lane departure. Transmission warning message in cluster (P074100 stored in TCM)
• 10122457May 1, 2014Electrical system, Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-01 dated April 24, 2013. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or ?Stuck Off? is stored in transmission control module (TCM), J217 (address word 03). The fault occurs with ATF temperature below 60o C. Check for this…
• 10122363Apr 30, 2014Equipment, Electrical system. The GPS location or vehicle direction indicated on the navigation map does not match the actual vehicle's location or actual direction of travel. The condition can happen sporadically or consistently. The condition does not happen during or immediately following the initial PDI inspection (once the vehicle has been taken out of transport mode). It is normal for the satellite reception to be 0 immediately after…
• 10122362Apr 30, 2014Equipment, Electrical system. Supersedes Technical Service Bulletin Group 91 number 13-17 dated December 3, 2013. The vehicle is a model year 2013 vehicle and TSB 2036607: 91 MMI3G+ Navigation GPS Location is inaccurate, has been completed. The GPS location or vehicle direction indicated on the navigation map does not match the vehicle's actual location or direction of travel.
• 10066389Apr 30, 2014Equipment. Summary to be provided on a future date.
• 10226431Apr 29, 2014Lane departure. Lane Change Assistant sporadically inoperative
• 10212673Apr 29, 2014Electrical system. Low battery charge: Diagnosis tips and TAC instructions
• 10210621Apr 29, 2014Electrical system. This TSB provides basic diagnosis steps for discharged batteries, general tips for working with batteries, and system verification steps to ensure that the vehicle is configured correctly. For additional information on known current draw issues, refer to the following TSBs: ? 2014127: 27 Battery dead or low after returning to the vehicle (2007 A6, A8, Q7) ? 2019143: 27 Battery discharged on some vehicles with…
• 10122369Apr 29, 2014Electrical system, Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-78 dated October 31, 2013. Audi side assist deactivates or is sporadically inoperative. Message "Side Assist Unavailable" is displayed in the driver information system display when the system deactivates. Audi side assist deactivates or is sporadically inoperative. DTCs are stored in the Lane change assistance control module. A software issue within J769…
• 10122336Apr 29, 2014Electrical system. Supersedes Technical Service Bulletin Group 27 number 12-12 dated February 28, 2012. Customer may report that the vehicle does not start due to a discharged battery. The vehicle has either a battery diagnostic management control module or a battery energy management control module. This TSB provides basic diagnosis steps for discharged batteries, general tips for working with batteries, and system verification…
• 10055841Apr 29, 2014Lane departure. Audi: on some vehicles, the side assist will be sporadically inoperative or will deactivates itself and message appears side assist unavailable.

← All problems reported for the 2013 Audi A7