2010 Audi Q7 Technical Service Bulletins

865 technical service bulletins (TSBs) are on record for the 2010 Audi Q7. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10123563Jun 12, 2013Lane departure, Visibility (wipers, defrost, mirrors). Supersedes Technical Service Bulletin Group 66 number 13-28 dated April 10, 2013. The customer may report hearing wind noise while driving at highway speeds. The noise may occur on either side of the vehicle. Wind noise may be coming from either the mirror base or the lane change assist lamp. Improved parts are available.
• 10243793Jun 10, 2013Equipment. Audi Elsa Newsletter
• 10243792Jun 3, 2013Equipment. Audi Elsa Newsletter
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10068707May 22, 2013Exterior lighting. Summary to be provided on a future date.
• 10052245May 22, 2013Exterior lighting. Audi: on some vehicles, the switch between rear lid tail lamp and bumper, does not switch over when lid is in operation, due to paddle, of rear sill trim, not contacting opposing lid latch points, uniformly. Models 2007-2014 q7, 2009-2014 q5. *pe updated 07/10/2013
• 10243994May 20, 2013Other or unknown. Elsaweb Newsletter
• 10228305May 20, 2013Engine cooling. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10224984May 20, 2013Transmission and drivetrain, Electrical system. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10221957May 20, 2013Transmission and drivetrain. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10124943May 20, 2013Electrical system. Supersedes Technical Service Bulletin Group 26 number 12-14 dated August 31, 2012. MIL on. DTCs is stored in the engine control module (ECM). Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10065349May 20, 2013Engine. Summary to be provided on a future date.
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10243993May 13, 2013Equipment. Elsaweb Newsletter
• 10228372May 13, 2013Fuel system, Electrical system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10225051May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10222024May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10124956May 13, 2013Electrical system. Supersedes Technical Service Bulletin Group 01 number 13-79 dated March 20, 2013. MIL on. DTCs are stored in the engine control module (address word 01). Excess rattling (?diesel clatter?) coming from engine. No start or hard starting condition. Contaminated fuel found in fuel system. Rust or metal debris found in fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery…
• 10065701May 13, 2013Fuel system. Summary to be provided on a future date.
• 10052289May 13, 2013Fuel system, Engine. Audi: the rail fuel pressure is too high. Fuel may be contaminated by rust or metal debris.
• 10251012May 8, 2013Suspension. Vehicle lowers itself, air suspension warning light on, level sensor error (PR-2MB or 1BK)
• 10251010May 8, 2013Suspension. Vehicle lowers itself, air suspension warning light on, software outdated (PR-2MB or 1BK)
• 10250679May 8, 2013Suspension, Air bags, Back-over prevention (rear camera), Lane departure…. Vehicle lowers itself, air suspension warning light on, level sensor error (PR-2MB or 1BK)
• 10250678May 8, 2013Air bags, Lane departure, Electronic stability control, Suspension. Vehicle lowers itself, air suspension warning light on, software outdated (PR-2MB or 1BK)
• 10066879May 8, 2013Suspension. Summary to be provided on a future date.
• 10066878May 8, 2013Electrical system. Summary to be provided on a future date.
• 10228366May 2, 2013Engine cooling. 01 MIL on (DTC P1196/P1197/P0135, heater circuit fault lambda sensor) - Repair Authorization
• 10225045May 2, 2013Electrical system. 01 MIL on (DTC P1196/P1197/P0135, heater circuit fault lambda sensor) - Repair Authorization
• 10222018May 2, 2013Electrical system. 01 MIL on (DTC P1196/P1197/P0135, heater circuit fault lambda sensor) - Repair Authorization
• 10124950May 2, 2013Electrical system. 01 MIL on (DTC P1196/P1197/P0135, heater circuit fault lambda sensor) - Repair Authorization.
• 10210672May 1, 2013Equipment, Electrical system, Other or unknown. The ignition key cannot be removed even though the gear shifter is in Park (P). The vehicle is mechanically in the Park position, but this is not recognized electronically. The gear shifter cannot be moved from the Park position.
• 10123933Apr 29, 2013Exterior lighting. The customer may report that the tail lamp lighting does not switch between the rear lid and the bumper when the lid is operated. DTC 03703 (Rear lid -closed- sensor) may be stored in the comfort system central control module, J393 (address word 46).
• 10068706Apr 29, 2013Exterior lighting. Summary to be provided on a future date.
• 10243785Apr 22, 2013Equipment. Audi Elsa Newsletter
• 10123932Apr 19, 2013Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 11-59 dated December 7, 2011. Bugs are trapped inside the rear taillight housing. Bugs can be seen inside the housing, and there are no external markings indicating the taillight has been hit or has been previously damaged due to outside influence. Bugs are able to enter the taillight housing because the seal around the housing is not tight enough.
• 10123925Apr 19, 2013Steering. Supersedes Technical Service Bulletin Group 48 number 11-15 dated January 10, 2011. The customer may report that the Easy Entry function of the power adjustable steering column intermittently does not work.
• 10068705Apr 19, 2013Exterior lighting. Summary to be provided on a future date.
• 10251011Apr 12, 2013Suspension. Self-leveling does not work: DTC 02645 stored
• 10250677Apr 12, 2013Suspension. Self-leveling does not work: DTC 02645 stored
• 10123921Apr 12, 2013Suspension. Self-leveling suspension cannot be adjusted during extremely cold weather. The self-leveling suspension warning light is illuminated in the instrument cluster. The self-leveling suspension operates normally again after the vehicle has been parked for a while in a garage or in the sun. DTC 20645 003 (valves for self-leveling control, mechanical fault) is present in the level control system module, J197 (address word…
• 10066877Apr 12, 2013Suspension. Summary to be provided on a future date.
• 10251009Apr 11, 2013Suspension. Self-leveling compressor inoperative
• 10250676Apr 11, 2013Suspension. Self-leveling compressor inoperative
• 10123920Apr 11, 2013Suspension. Supersedes Technical Service Bulletin Group 43 number 12-11 dated October 29, 2012. The self-leveling system can no longer be adjusted with the MMI. The compressor for the self-leveling system continues to run after the engine has been switched off and the vehicle has been locked. DTCs may be stored in the level control system module, J197 (address word 34). Because of poor performance or failure of the air…
• 10123927Apr 10, 2013Body and structure, Visibility (wipers, defrost, mirrors). Supersedes Technical Service Bulletin Group 66 number 12-23 dated August 3, 2012. The customer may report hearing wind noise while driving at highway speeds. The noise may occur on either side of the vehicle. Wind noise may be coming from either the mirror base or the lane change assist lamp. Improved parts are available.
• 10066982Apr 10, 2013Visibility (wipers, defrost, mirrors). Summary to be provided on a future date.

← All problems reported for the 2010 Audi Q7