2014 Audi RS 5 Technical Service Bulletins

681 technical service bulletins (TSBs) are on record for the 2014 Audi RS 5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10221966Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10123559Jun 19, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 10-68 dated October 26, 2010. The MMI control knob joystick is loose or has fallen off. Only vehicles with navigation and without MMI touch are affected.
• 10251014Jun 17, 2013Suspension, Electronic stability control. Replaced adaptive damping suspension control module cannot be coded
• 10123577Jun 17, 2013Suspension. The adaptive damping suspension control module, J250, cannot be coded via SVM spec/actual after it has been replaced. A new generation of the adaptive damping suspension control module, J250, was placed into production. The new generation control module must be coded and parameterized using an SVM code, which is listed in the attached ETKA Parts Bulletin, 9-119. This parts bulletin can be found in the ETKA Remarks…
• 10123548Jun 12, 2013Equipment. Audi is committed to enhancing the Initial Quality Experience for our Customers within the first days of vehicle ownership. We want to resolve any knowledge or technical concerns a customer may have about a new vehicle, and build a strong, positive, enduring relationship between dealer and customer. To support this commitment to both our dealers and our customers, Audi is introducing the Audi Second Delivery…
• 10123572Jun 11, 2013Equipment. Customer may report that the ceramic brakes are noisy. Various parts have been replaced under warranty for the condition noted above, but no issues were identified with these parts. In an effort to gain information, we are asking that you contact the Audi Technical Assistance Center (TAC) before replacing any parts.
• 10243793Jun 10, 2013Equipment. Audi Elsa Newsletter
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10243995May 28, 2013Equipment. Elsaweb Newsletter
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10052352May 14, 2013Latches, locks and linkages. Audi: some vehicles, in cold weather, occasionally, cannot be unlocked using the door handle touch sensor. Also inclded are model a4 my 2014, model a5 cabriolet my 2014, model q5 my 2014, model rs5 cabriolet my 2014, and model s5 cabriolet my 2011-2014.
• 10226464Mar 27, 2013Air bags, Lane departure. ABS warning light on - wire harness damage
• 10123846Mar 27, 2013Steering. Steering wheel lock does not work. Various warning lights are on. Steering feels stiffer than usual. The engine cannot be switched off. The ignition key cannot be removed. DTC with description "Brake control unit, no signal/communication" is present in several control units. DTC entry in ABS Control unit, J104 (03). One or more may be present. This condition does not result in any drivability concerns. The steering…
• 10123862Mar 20, 2013Body and structure, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 12-73 dated September 24, 2012. The exterior door handle touch sensors (Advanced key) are inoperative on one or several doors. The key blade can be used mechanically (driver door or trunk) or remote electrically (key remote buttons) to unlock and lock the vehicle.
• 10251023Feb 18, 2013Suspension. Steering wheel shimmy, vibration and/or oscillation
• 10250475Feb 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10250423Feb 14, 2013Engine cooling. Idle speed characteristic during cold start
• 10123969Feb 14, 2013Engine cooling. Supersedes Technical Service Bulletin Group 01 number 12-57 dated October 29, 2012. Noises/inconsistent engine operation after cold start during the catalyst heating phase. The customer may interpret this engine roughness as misfiring. To comply with the legal requirements on exhaust gas emissions according to the LEV-1 and LEV-2 standards, a high exhaust gas quality must be ensured. The necessary catalyst only…
• 10251018Jan 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10243887Jan 10, 2013Equipment. Informe del técnico de Audi
• 10243886Jan 10, 2013Equipment. Informe del técnico de Audi
• 10216682Jan 9, 2013Engine cooling. Engine oils that meet Audi Oil Quality Standards.
• 10244038Jan 3, 2013Equipment. 2014 Scheduled Maintenance Intervals
• 10121550Dec 12, 2012Equipment. This document contains the scheduled maintence intervals.
• 10122674Dec 7, 2012Electrical system, Equipment. The customer may state that the outside ambient temperature display is incorrect. To achieve a smoothening effect of the displayed outside ambient temperature, the value shown does not instantaneously follow the temperature sensor measurement. The display will not change faster than 4° F (2° C) per minute. This concept applies to both falling and rising temperatures.
• 10250415Oct 29, 2012Engine cooling. Idle speed characteristic during cold start
• 10122803Oct 29, 2012Engine cooling. Supersedes Technical Service Bulletin Group 01 number 12-51 dated July 18, 2012. Noises/inconsistent engine operation after cold start during the catalyst heating phase. The customer may interpret this engine roughness as misfiring. To comply with the legal requirements on exhaust gas emissions according to the LEV-1 and LEV-2 standards, a high exhaust gas quality must be ensured. The necessary catalyst only…
• 10063095Oct 29, 2012Engine. Summary to be provided on a future date.

← All problems reported for the 2014 Audi RS 5