2014 Audi RS 5 Technical Service Bulletins

681 technical service bulletins (TSBs) are on record for the 2014 Audi RS 5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10122465May 28, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-07 dated May 29, 2013. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off). No DTCs are stored. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left…
• 10122452May 28, 2014Engine, Equipment. Supersedes Technical Service Bulletin Group 00 number 13-49 dated May 14, 2013. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating…
• 10249085May 13, 2014Other or unknown. Google Maps Street View (NVLW))
• 10122472May 2, 2014Electrical system. Supersedes Technical Service Bulletin Group 64 number 12-22 dated July 5, 2012. After one or both of the front door control units (J386/J387) is replaced, one or both of the rear door control units (J3888/J389) cannot be coded or parameterized via an SVM specified vs. actual comparison (spec/actual). The parameter data in the software coding container has changed for the front and rear door control units.
• 10066330May 2, 2014Electrical system. Summary to be provided on a future date.
• 10212672Apr 24, 2014Equipment, Body and structure. Vibrations felt at 1000 rpm and 3000 rpm
• 10250974Apr 14, 2014Brakes. Ceramic brake repair authorization.
• 10250106Apr 14, 2014Equipment. Elsa newsletter
• 10122340Apr 14, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 13-44 dated June 11, 2013. Customer may report that the ceramic brakes are noisy. Various parts have been replaced under warranty for the condition noted above, but no issues were identified with these parts. In an effort to gain information, we are asking that you contact the Audi Technical Assistance Center (TAC) before replacing any parts. This will assist us…
• 10066044Apr 14, 2014Brakes. Summary to be provided on a future date.
• 10055796Apr 14, 2014Brakes. Audi: the ceramic brakes on vehicles are very noisy and need replacing and while under warranty, various parts have been replaced.
• 10250179Apr 7, 2014Equipment. Elsa newsletter
• 10243823Apr 3, 2014Visibility (wipers, defrost, mirrors). AC Pressure/Temperature Sensor (NVLW)
• 10231131Apr 3, 2014Equipment. Technical bulletins and updates
• 10216651Apr 3, 2014Back-over prevention (rear camera). The customer complains of one or more of the following issues: ? When the vehicle is completely refueled, the vehicle range (?distance to empty?) that is displayed is different than the vehicle range that was displayed the last time the vehicle was completely refueled. ? The displayed vehicle range drops inconsistently. ? After the vehicle is refueled, the displayed vehicle range does not change for a long period…
• 10122410Apr 3, 2014Equipment. On Audi vehicles manufactured within a specific period, the refrigerant pressure sensor for the air conditioner may fail after a period of time. As a result, the air conditioner compressor is switched off. This Update is in effect until removed. Procedure is valid only for vehicles that show the 87D9 code in the Elsa Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle…
• 10249053Apr 2, 2014Engine cooling, Other or unknown. AC Pressure/Temperature Sensor
• 10242668Apr 1, 2014Engine cooling. The Audi 2.0L Third Generation TDI Engine
• 10231135Mar 31, 2014Equipment. Technical bulletins and updates
• 10122295Mar 31, 2014Air bags. Supersedes Technical Service Bulletin Group 69 number 13-26 dated October 21, 2013. After the airbag control module (J234) has been replaced, the control unit cannot be coded via SVM spec/actual. An SVM code is required to code and parameterize the new service replacement airbag control module. Each model's SVM code is provided in a parts bulletin (GP bulletin), which should have been referenced through ETKA when…
• 10250991Mar 25, 2014Brakes. Brake noise analysis and handling
• 10122292Mar 25, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-68 dated February 3, 2014. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
• 10231133Mar 17, 2014Equipment. Technical bulletins and updates
• 10125561Feb 27, 2014Equipment. Supersedes Technical Service Bulletin Group 87 number 12-27 dated April 24, 2012. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor.
• 10228292Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10221944Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10125536Feb 20, 2014Electrical system. Supersedes Technical Service Bulletin Group 00 number 12-34 dated June 6, 2012. The process of draining oil through the drain plug is not always tidy. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10231119Feb 17, 2014Equipment. Technical bulletins and updates
• 10212670Feb 11, 2014Body and structure, Equipment. Vibrations felt at 1000 rpm and 3000 rpm
• 10125567Feb 11, 2014Electrical system. Vibrations are felt at 1000 rpm and 3000 rpm. DTCs are stored in the subframe mount control module. The basic settings of the active engine mounts in the subframe mount control module, J931, are deactivated when work is done on either of the vehicle electrical system control modules, J519 and/or J520 (for example, when a key is programmed). As a result, the vehicle vibrates or judders when cylinders are actively…
• 10250993Feb 3, 2014Brakes. Brake noise analysis and handling
• 10231117Feb 3, 2014Equipment. Technical bulletins and updates
• 10125548Feb 3, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-67 dated January 21, 2014. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. This TSB should not be used if another brake noise TSB is available…
• 10251028Jan 21, 2014Steering. Alignment - Repair Authorization
• 10122193Jan 21, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-64 dated January 2, 2014. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10122189Jan 21, 2014Wheels, Steering. Supersedes Technical Service Bulletin Group 44 number 13-39 dated July 12, 2013. Vehicle pulls (left or right). Steering wheel is not level or is off-center. These conditions may be noticed during PDI. If the condition is due to outside influence (such as an accident), this TSB does not apply. In an effort to gain information on this condition, Audi of America is asking you to contact the Audi Technical Assistance…
• 10231122Jan 20, 2014Equipment. Technical bulletins and updates
• 10231121Jan 13, 2014Equipment. Updates and suggestions
• 10122192Jan 9, 2014Brakes, Steering, Wheels. Supersedes Technical Service Bulletin Group 46 number 12-23 dated June 18, 2012. Customer may report that the steering wheel vibrates or pulsates when the brakes are applied. Document contains the brake pulsation diagnostic guidelines.
• 10122199Jan 3, 2014Electrical system. Supersedes Technical Service Bulletin Group 91 number 11-16 dated October 5, 2011. During a Bluetooth call, the sound is difficult to hear for the other party. Voice recognition accuracy is poor. This TSB provides guidelines for testing microphones in a vehicle.
• 10122190Jan 2, 2014Brakes. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10216606Jan 1, 2014Brakes. Tire Pressure Table.
• 10216605Jan 1, 2014Brakes. Tire Pressure Table.
• 10216600Jan 1, 2014Equipment. Maintenance.
• 10243767Dec 16, 2013Equipment. Audi Elsa Newsletter
• 10121447Dec 16, 2013Equipment. This document contains the Audi delivery report checklist. This document is in Spanish.
• 10121445Dec 16, 2013Equipment. This document contains the Audi delivery report checklist. This document is in Spanish.
• 10121460Dec 12, 2013Tires, Equipment. This document contains the Audi normal load condition tire pressure table. This document is in Spanish.
• 10251027Dec 9, 2013Wheels. Tightening wheel bolts
• 10121408Dec 9, 2013Wheels. Supersedes Technical Service Bulletin Group 44 number 12-32 dated August 2, 2012. Wheel bolt requires torque adjustment. Torque sticks, torque extension bars, and impact guns/wrenches are not approved by Audi of America, Inc., and should not be used to apply torque to wheel bolts. Always use a calibrated torque wrench to attain the correct wheel bolt torque and follow the proper wheel tightening procedure as…

← All problems reported for the 2014 Audi RS 5