2018 BMW X2 Technical Service Bulletins

109 technical service bulletins (TSBs) are on record for the 2018 BMW X2. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 11035496Jun 26, 2026Engine. The EVAP systems purge (vent) valve limited warranty for defects in materials and / or workmanship has been extended to 15 years / 150,000 miles as determined from the original first in-service / delivery date.
• 11032730May 5, 2026Engine. The EVAP systems purge (vent) valve limited warranty for defects in materials or workmanship has been extended to 15 years / 150,000 miles as determined from the original in-service date.
• 11013037Jan 16, 2025Electrical system. The Telematics Control Units (TCU) Internal Emergency (Backup) Battery for defects in materials and/or workmanship has been extended to 6 years without mileage limitation, as determined from the vehicles original first in-service / delivery date. This coverage is subject to the same vehicle eligibility requirements, limitations, and exclusions that apply to the BMW New Vehicle Limited Warranty.
• 11012111Dec 31, 2024Electrical system. The Telematics Control Units (TCU) Internal Emergency (Backup) Battery for defects in materials and/or workmanship has been extended to 6 years without mileage limitation, as determined from the vehicles original first in-service / delivery date.
• 11000578May 2, 2024Engine. Evap system purge (vent) valve ext ltd wty (elw) 15/150
• 10252135Mar 25, 2024Electrical system. After performing a BMW Remote Software Upgrade (RSU), the functionality of the Comfort Access andPassive Go/Exit features may be reduced. Also, one or more of the following error memory entries below may be stored in the Basic Central Platform(BCP) module.
• 10252033Mar 14, 2024Suspension. During inspection and/or diagnosis there is noticeable dirt/grease buildup on the axles near the inner and/o router CV boots.
• 10249435Jan 19, 2024Body and structure. Customer complains of a musty odor or damp front footwell carpet.
• 10249027Jan 11, 2024Electrical system. The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle “discharged battery” complaints.
• 10242874Sep 11, 2023Equipment. Customers may be experiencing one or more of these following issues with Bluetooth operation: Bluetooth cannot be switched on or off in the head unit (HU-H4) Paired mobile devices cannot be deleted Customer is unable to make phone calls or stream music with mobile device Customer is unable to connect a new mobile device via Bluetooth Mobile device does not automatically reconnect via Bluetooth in the next drive…
• 10238090May 1, 2023Electrical system. After programming the head unit (HU-H2), activating the FSC (German word Freischaltcode) Enabling Codes repeatedly fails.
• 10238081May 1, 2023Body and structure. Upon opening and closing the tailgate, a creaking/groaning sound can be heard from tailgate actuator.
• 10235205Mar 1, 2023Equipment, Electrical system. The 3G network in the US has been shut down. This means that only the 4G network will be available. In the 4G network, voice calls will be transferred via the Voice over LTE (VoLTE) function. For this purpose, the SIM card must perform an IMS registration in the mobile communication network. Due to a production error, the telematics control units were delivered without an IMS configuration.
• 10235192Mar 1, 2023Exterior lighting, Electrical system. The buttons on the gear selector switch (GWS) do not work, or the function indicator lighting has failed.
• 10235183Mar 1, 2023Electrical system. While driving on rough roads, a knocking sound can be heard coming from top of the instrument panel (aka dashboard) in the bulkhead area.
• 10228428Nov 1, 2022Engine cooling. During load reversal or taking off from a stop, there is a creaking or droning noise heard from the lower engine area.
• 10228427Nov 1, 2022Engine cooling. During a vehicle inspection and/or while addressing a customer's concern, the engine stabilizer bar/link appears to be worn.
• 10218420Jul 1, 2022Equipment, Electrical system. The 3G network in the US has been shut down. This means that only the 4G network will be available. In the 4G network, voice calls will be transferred via Voice over LTE (VoLTE) function. For this purpose the SIM card must perform an IMS registration in the mobile communication network. Due to a production error, the telematics control units were delivered without an IMS configuration.
• 10218373Jun 1, 2022Visibility (wipers, defrost, mirrors), Electrical system. Any or all of these conditions may be present: A. The exterior rearview mirror glass is discolored or cracked B. The power windows and folding mirrors may not operate C. One or more of the following LIN bus faults are stored in the BDC (Body Domain Controller): Faulty exterior rearview mirror electronics have created a short on the LIN bus, damaging the mirror glass and causing functional errors in power window and…
• 10215752May 1, 2022Equipment, Steering. The following complaints may be noticed while slow maneuvering with a steering input of 80-100% (at or near full lock, e.g., parking lot maneuvers) or accelerating with a medium to large steering angle: Humming or creaking noises from the rear area, slight vibrations also noticeable from the driver's seat. The vehicle may also jerk slightly.
• 10214989May 1, 2022Engine cooling. Mist formation on the windshield inside surface may occur at departure or after MSA (automaticstart/stop). Acoustic abnormality in the area of the recirculated air flap (recirculation flap closing and opening severaltimes). The above may occur individually or in combination.
• 10212796Apr 1, 2022Electrical system. The Check Control message "Door open" appears in the instrument cluster (Kombi) even though all vehicle doors are closed and locked. The locking operation of the doors is not affected.
• 10214256Feb 1, 2022Engine cooling, Fuel system. The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.
• 10212525Feb 1, 2022Equipment. Customer complains of musty odor or damp front footwell carpet.
• 10206685Dec 1, 2021Latches, locks and linkages, Body and structure. Any or all of the following CCM ID code 14/15/16/17 "door open" appear in the instrument cluster when the door is properly closed and locked. The locking operation of the door is not affected by the incorrect display.
• 10204657Sep 1, 2021Engine cooling. Different air temperatures are felt from left to right out of the front fresh air grilles (air vents).
• 10201145Jul 1, 2021Equipment. Different air temperatures are felt from left to right out of the front fresh air grilles (air vent). The following fault code is saved in the IHKA (integrated automatic heating/air conditioning system) control unit: 801189 - Engine mixed air right: Initialization fault.
• 10200246Jun 1, 2021Body and structure, Equipment, Electrical system. Customer states the Central Information Display is flickering and the picture is shifting.
• 10188944Feb 1, 2021Visibility (wipers, defrost, mirrors). LIN BUS FAULTS WITH EXTERIOR REARVIEW MIRROR GLASS DAMAGE: Faulty exterior rearview mirror electronics have created a short on the LIN bus, damaging the mirror glass and causing functional errors in power window and exterior mirror operation.
• 10184587Nov 1, 2020Equipment, Body and structure. Water Ingress In Footwell Area From A/C Condensate Drain: Water Ingress In Footwell Area From A/C Condensate Drain. Customer complains of musty odor or damp front footwell carpet.
• 10184584Nov 1, 2020Equipment, Visibility (wipers, defrost, mirrors). Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full: Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full.There are no faults stored in the system for the washer fluid level switch.
• 10182921Oct 1, 2020Equipment. CONDENSATION FROM AIR CONDITIONING LEAKS INTO PASSENGER FOOTWELL: Condensation from the air conditioning systems evaporator drips, below the instrument panel, into the passenger's footwell. During assembly, the cover of the fresh air intake was not fully seated when the screws were tightened. This cover can then leak condensation out through the existing gap.
• 10182920Oct 1, 2020Equipment. BUZZING NOISE IS HEARD WHEN AIR CONDITIONING IS DEACTIVATED: A buzzing noise is heard when the air conditioning (A/C) is deactivated while the vehicle is in park or neutral. Prior to turning off the A/C, the system was functional and cooling properly. A/C compressor, or The power supply to the A/C compressor is too low.
• 10182622Oct 1, 2020Equipment, Body and structure. CONDENSATION FROM AIR CONDITIONING LEAKS INTO PASSENGER FOOTWELL: Condensation from the air conditioning systems evaporator drips, below the instrument panel, into the passenger's footwell. During assembly, the cover of the fresh air intake was not fully seated when the screws were tightened. This cover can then leak condensation out through the existing gap.
• 10182621Oct 1, 2020Equipment. BUZZING NOISE IS HEARD WHEN AIR CONDITIONING IS DEACTIVATED: A buzzing noise is heard when the air conditioning (A/C) is deactivated while the vehicle is in park or neutral. Prior to turning off the A/C, the system was functional and cooling properly. A/C compressor, or The power supply to the A/C compressor is too low.
• 10181224Sep 1, 2020Electrical system. SERVICE ACTION - PROGRAM THE BODY DOMAIN CONTROL (BDC) UNIT: Aftermarket scan tools cannot read fault codes in the Dynamic Stability Control (DSC) unit via the On-Board Diagnostic (OBD) socket. The DSC data is not processed correctly in the BDC and therefore cannot transmit any diagnostic requests via the OBD using aftermarket scan tools.
• 10179813Aug 1, 2020Electronic stability control. DELIVERY STOP - OBD ACCESS IN DSC CONTROL UNIT: Aftermarket scan tools cannot read fault codes in the Dynamic Stability Control (DSC) unit via the On Board Diagnostic (OBD) socket. The DSC data is not processed correctly in the BDC and therefore cannot transmit any diagnostic requests via the OBD using aftermarket scan tools.
• 10179009Jul 1, 2020Electrical system. NAVIGATION SYSTEM - REPORTING MISSING OR INCORRECT ROADMAP DATA: Do not replace parts and do not program the vehicle. Roads can change by up to 15% every year. To ensure the best navigation experience, we do everything in our power to create the best maps. Your reports help us to detect changes in your area and keep future versions of our maps as accurate as possible. Therefore, a road map error or missing data…
• 10178996Jul 1, 2020Wheels, Brakes. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: Ticking noise coming from front wheel while cornering without brakes applied, noticeable at low speeds. The vehicle must be moving.
• 10176377May 1, 2020Electrical system. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases…
• 10176370May 1, 2020Visibility (wipers, defrost, mirrors), Electrical system, Transmission and…. LIN BUS FAULTS WITH EXTERIOR REARVIEW MIRROR GLASS DAMAGE: Any or all of these conditions may be present: A. The exterior rearview mirror glass is discolored or cracked B. The power windows and folding mirrors may not operate C.
• 10176363May 1, 2020Engine cooling. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME.
• 10176362May 1, 2020Electrical system, Exterior lighting. ROUGH RUNNING IMMEDIATELY AFTER A COLD START: Immediately after a cold start the engine may run roughly during the catalyst heating period.
• 10174320Apr 1, 2020Electrical system, Equipment. CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both…
• 10174032Apr 1, 2020Equipment. AUTOMATED ACTIVATION OF NAVIGATION SYSTEM DURING PDI/QC1: This Service Information Bulletin (Revision 2) replaces SI B65 22 14 dated October 2015. The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department!
• 10174023Apr 1, 2020Steering, Electronic stability control, Suspension, Electrical system. CHECK CONTROL MESSAGES FOR BRAKE SUSPENSION AND AIR BAG SYSTEM MALFUNCTION: Multiple check control messages (CCM) can display for brake suspension and air bag system malfunction.
• 10174019Apr 1, 2020Engine. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this…
• 10174015Apr 1, 2020Air bags, Brakes. TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
• 10172500Feb 1, 2020Engine cooling. Water Ingress In Footwell Area From A/C Condensate Drain: This Service Information Bulletin (Revision 1) replaces SI B64 04 16 dated March 2016. The condensate drain hose is blocked by the heat shield The condensate drain hose is not attached properly to the housing The condensate drain hose was damaged during installation
• 10172497Feb 1, 2020Electrical system. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases…

← All problems reported for the 2018 BMW X2