2020 BMW X3 Technical Service Bulletins

286 technical service bulletins (TSBs) are on record for the 2020 BMW X3. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10174015Apr 1, 2020Brakes, Air bags. TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
• 10174013Apr 1, 2020Suspension, Vehicle speed control, Back-over prevention (rear camera)…. G01 WIND NOISE DIAGNOSIS: Customer complaint of hissing or wind noise present in the interior of the vehicle at speeds above 60 mph. CAUSE The following areas and defects may cause this complaint: 1. A pillar gutter trim not correctly installed. 2. Door seal not correctly installed or a gap exists between the seal and the body. 3. Side view mirror cover deformity. 4. Improper door adjustment. 5. Side view mirror…
• 10174011Apr 1, 2020Equipment. UNINTENDED HATCH ACTIVATION AFTER CONVERSION: The hatch may unintentionally open.
• 10174009Apr 1, 2020Transmission and drivetrain, Brakes, Wheels, Back-over prevention (rear camera). TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12.
• 10174005Apr 1, 2020Engine cooling. DME FC 21A02D - COMBUSTION CONTROL: VALVE LIFT AT IDLE This Service Information Bulletin (Revision 3) replaces SI B12 13 18 dated September 2019. The vehicle will run rough or hesitate when accelerating from a stationary position.
• 10174004Apr 1, 2020Engine cooling. DELIVERY STOP: PROGRAM CONTROL UNITS (DME): BMW AG has issued a Delivery Stop (effective March 5 2020) on a small number of Model Year 2020 BMW vehicles that were produced starting on February 14 2018. Vehicles that are currently being produced will be added to this campaign daily until March 22 2020. Vehicles produced on March 23 2020 and onward will not be affected. An error in the digital motor electronics (DME)…
• 10174002Apr 1, 2020Lane departure. ENGINE: FAULTS FOR TURBOCHARGER ELECTRIC WASTEGATE STORED IN THE DME: This Service Information Bulletin (Revision 1) replaces SI B12 01 20 dated January 2020. The engine malfunction warning (MIL) is illuminated and one of the following fault codes is stored in the DME.
• 10172497Feb 1, 2020Electrical system. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases…
• 10172487Feb 1, 2020Engine cooling. ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the…
• 10171503Jan 1, 2020Electrical system. REMOTE 3D VIEW NOT AVAILABLE: Remote 3D View cannot be launched In the BMW ConnectedDrive App. Software error in the Advanced Telematics Module 2 (ATM2).
• 10171502Jan 1, 2020Electrical system. BMW CONNECTEDDRIVE SERVICES ARE NOT AVAILABLE: The BMW ConnectedDrive services are not available for an extended period. This may include: Calls in the BMW Assistance app (Concierge Service) Vehicle data and status in the BMW ConnectedDrive app Remote services Remote 3D View Real Time Traffic Information (RTTI) Weather News Software error in Advanced Telematics Module 2 (ATM2).
• 10171500Jan 1, 2020Electrical system, Steering. LDW (LANE DEPARTURE WARNING): STEERING WHEEL VIBRATION NOT STRONG This Service Information Bulletin (Revision 2) replaces SI B66 21 19 dated December 2019. Lane Departure Warning (LDW) steering wheel vibration is perceived as being not strong enough even with the strongest setting selected via the iDrive menu. Software in the vibration actuator and /or steering wheel component.
• 10171498Jan 1, 2020Back-over prevention (rear camera), Electrical system. REAR VIEW CAMERA FAILS TO DISPLAY IMAGE: This Service Information Bulletin (Revision 5) replaces SI B66 08 17 dated March 2018. Sporadically when the rear view camera is activated no image appears in the display. The rear view camera can be activated by either: 1. Selecting reverse with the shift selector 2. Camera activation via the button on the center console Camera function returns after a terminal change…
• 10171481Jan 1, 2020Engine cooling. FAULTS FOR TURBOCHARGER ELECTRIC WASTEGATE STORED IN THE DME. The engine malfunction warning (MIL) is illuminated and one of the following fault codes is stored in the DME. 123518 - electrical wastegate valve 2 wastegate valve: stiff movement And/or 120408 - charging pressure control: Switch-off as a secondary reaction CAUSE The DME has an adaptation error when calculating the setpoint values of the two electric…
• 10171480Jan 1, 2020Engine cooling. SERVICE ACTION: S58T ENGINE - CHECK ENGINE OIL DEFLECTOR SCREWS: The engine oil deflector screws may have been tightened to the wrong torque.
• 10171479Jan 1, 2020Engine cooling. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects…
• 10171414Jan 1, 2020Air bags. SIDE PANEL REAR LIGHT HOUSINGS: LTD WTY EXT TO 10 YEARS WITHOUT MILEAGE LIMIT: The rear light housing(s) can loosen/detach at the mounting tabs this can cause a clacking sound in the rear of the vehicle while driving. The plastic mounting tabs for the rear tail light assembly housing(s) may become too brittle and crack to the point where the hold down nut(s) can no longer keep the housing(s) in place.
• 10170591Dec 1, 2019Back-over prevention (rear camera), Lane departure. TOP VIEW CAMERA: IMAGE IS MISALIGNED. The top view image of the vehicle is misaligned when observed in the Control Information Display (CID). When the vehicle is parked in a parking spot with line markings it is clearly noticed in the CID that the lines are not parallel to the side of the vehicle. This may be noticed on either the driver side passenger side or both. The arrow identifies the line which is shown as…
• 10170590Dec 1, 2019Lane departure, Steering. LDW (LANE DEPARTURE WARNING) STEERING WHEEL VIBRATION NOT STRONG: Lane Departure Warning (LDW) steering wheel vibration is perceived as being not strong enough even with the strongest setting selected via the iDrive menu. Software in the vibration actuator and /or steering wheel component.
• 10170589Dec 1, 2019Brakes. INCORRECT CONDITION BASED SERVICE DATA FOR BRAKE FLUID SERVICE. "Brake fluid service due since 12/2001" is displayed in the instrument cluster although the vehicle is only a maximum of 1 year old. Software error in the KOMBI (Instrument Cluster).
• 10170588Dec 1, 2019Electrical system. INSTRUMENT CLUSTER REMAINS DARK AFTER STARTING THE VEHICLE: Instrument cluster remains dark after starting the vehicle. After a restart normal functionality is restored. Software error in the KOMBI (Instrument Cluster).
• 10170587Dec 1, 2019Electrical system. COMPASS NO LONGER VISIBLE IN THE KOMBI AFTER PROGRAMMING: Integration level updated. Customer noticed that their compass display was deleted from the Instrument Cluster (KOMBI) after recent programming. It still appears in the CID widget display. Software error in the KOMBI.
• 10170577Dec 1, 2019Brakes. HELPFUL INFORMATION FOR CUSTOMER DISCUSSIONS REGARDING MOTORSPORT VEHICLE BRAKES: Note for customer deleted: If the noise does not disappear despite the attempts to regenerate the brake a repair is required.
• 10170573Dec 1, 2019Engine cooling, Electrical system. DELIVERY STOP: PROGRAM CONTROL UNITS (DME). BMW of North America LLC has issued a Delivery Stop (effective December 5 2019) on certain Model Year 2020 BMW vehicles that were produced between March 2019 and December 2019. An error in the oxygen sensor on-board diagnosis (OBD) may not properly illuminate the malfunction indicator lamp (MIL) when a fault is detected. A software error in the digital motor electronics…
• 10170572Dec 1, 2019Electrical system. ENGINE DOES NOT START BELOW FREEZING TEMPERATURES: Engine designation correction Parts availability Warranty. The engine will not start at temperatures below freezing. The starter does not turn and engage.
• 10170570Dec 1, 2019Engine, Equipment. SERVICE ACTION: S58T ENGINE - CHECK ENGINE OIL DEFLECTOR SCREWS. The engine oil deflector screws may have been tightened to the wrong torque.
• 10170569Dec 1, 2019Exterior lighting, Engine cooling. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME).
• 10169474Nov 1, 2019Equipment. NO AUDIO IS AVAILABLE FOR APPROXIMATELY 30 SECONDS AFTER HEAD UNIT START UP: After programming vehicle no audio is available for approximately 30 seconds after head unit start-up. Fault code B7F490 "Control unit reset" is present in the RAM (Receiver Audio Module).
• 10169472Nov 1, 2019Equipment, Electrical system. ENGINE SPEED DEPENDENT NOISE DURING AUDIO PLAYBACK: Integration level updated. There is an engine speed-dependent noise heard through the speakers during audio playback. Software error in the Receiver Audio Module (RAM) control unit.
• 10169469Nov 1, 2019Equipment, Electrical system. INSTRUMENT CLUSTER AND ONBOARD COMPUTER INTERMITTENTLY INOPERATIVE: Instrument Cluster (KOMBSP18) functions are intermittently inoperative including: On-board Computer (BC) button on turn signal stalk (BC button shown at left) Radio displays Menu button Turn signal displays Arrows on multifunction steering wheel MFL thumbwheel control.
• 10169468Nov 1, 2019Equipment, Visibility (wipers, defrost, mirrors). Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full : The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch. A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain…
• 10169460Nov 1, 2019Equipment, Brakes. HELPFUL INFORMATION FOR CUSTOMER DISCUSSIONS REGARDING MOTORSPORT VEHICLE BRAKES: INFORMATION Inform the customer during a consultation that the M Compound (standard equipment) and M Carbon Ceramic (optional) brakes are high-performance brake systems which are designed for sporty dynamic driving styles. As a side effect of the highest possible brake performance customers are likely to hear noises due to the…
• 10167993Oct 1, 2019Engine cooling. DELIVERY STOP: CYLINDER HEAD COVER DELIVERY STOP: CYLINDER HEAD COVER. The cylinder head cover may have been damaged during assembly. It will need to be inspected and, if necessary, replaced.
• 10166389Sep 1, 2019Engine cooling, Equipment. SERVICE ACTION: CHECKING HEATER HOSE FOR PROPER INSTALLATION: The installation area between the heater return hose and the drive belt is very limited. If the hose is not secured properly this could cause contact with the drive belt. Limited space between the heater hose and the drive belt along with possible incorrect clip installation.
• 10166383Sep 1, 2019Equipment, Visibility (wipers, defrost, mirrors), Body and structure. SUNROOF WATER LEAK DIAGNOSIS: This bulletin outlines multiple known areas of possible water entry for the vehicles listed above. It serves only as a diagnostic resource in troubleshooting water leak complaints from the roof area.
• 10166229Sep 1, 2019Suspension. Front Suspension Ride Height Has Dropped: The front suspension ride height has dropped on one or both sides due to overload. This is caused by driving over obstacles (e.g. potholes) or an impact severe enough for the front spring strut damper to slip through the clamp of the steering knuckle.

← All problems reported for the 2020 BMW X3