2017 Chevrolet Silverado 3500 Technical Service Bulletins

932 technical service bulletins (TSBs) are on record for the 2017 Chevrolet Silverado 3500. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10168214Oct 8, 2019Other or unknown. This preliminary bulletin provides a procedure to reprogram more than 8 keys for the PPV.
• 10168176Oct 8, 2019Transmission and drivetrain. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
• 10168204Oct 2, 2019Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10168188Oct 2, 2019Equipment. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
• 10168177Oct 1, 2019Engine cooling. This bulletin provides information on common diesel engine tick noises and how they are considered part of normal operation and no parts should be replaced for these normal operating conditions.
• 10166665Sep 30, 2019Fuel system. This Informational Bulletin provides information on availability of Diesel Fuel additives.
• 10166659Sep 20, 2019Engine cooling. This diagnostic tip provides additional information on how to diagnose a possible valve, lifter or camshaft issue.
• 10166638Sep 18, 2019Equipment. This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
• 10166635Sep 16, 2019Engine cooling. This diagnostic tip provides information to the tech to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away.
• 10165877Sep 6, 2019Electrical system. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10165874Sep 5, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact PARTECH and/or the Techline Customer Support Center for additional support.
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10164754Aug 7, 2019Equipment. This preliminary information explains that there are differences between the Elevated Idle, PTO and High Idle options.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10163686Jul 30, 2019Equipment. This Preliminary information communicates additional information on how a LIN bus operates and diagnostic tips when working on a LIN bus.
• 10163681Jul 29, 2019Equipment. This Preliminary information communicates that when a customer or technician attempts to add a new transmitter to a vehicle following the adding transmitters without Service Programming System procedure the procedure will not complete and a message "Remote Learn Pending" will be displayed on the Driver Information Center. In the past to perform the new transmitter procedure only one previously learned transmitter…
• 10163900Jul 26, 2019Equipment. This informational bulletin provides process information for the (GWM) and (WPC) parts return program.
• 10163854Jul 26, 2019Fuel system, Engine. N182198000 - Special Coverage Adjustment - Certain vehicles, equipped with a 5.3L or 6.2L engine, may have a condition which affects fuel injector function. Under certain circumstances one or more of the vehicle?s fuel injectors may deliver an improper amount of fuel to the engine. If this occurs, the Malfunction Indicator Lamp (Check Engine Light) will illuminate, the engine may idle or run rough, and the vehicle…
• 10165334Jul 16, 2019Equipment. This SKU is a Tire Hoist Assembly. The customer communication requested return of unsold inventory to inspect for the shape of the centerpiece of the tire hoist being round when it should be square. If the centerpiece is the incorrect shape then the tire hoist cannot be operated with the OE tools, and the end user would therefore not be able to lower the spare tire with the vehicles original tools.
• 10163665Jul 16, 2019Wheels, Vehicle speed control. This Preliminary information communicates direction and examples when diagnosing multiple DTCs, one of which includes U**** Byte 71 DTC.
• 10163659Jul 10, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10163193Jun 25, 2019Equipment. This bulletin provides information on Engine Concerns that could result from lack of scheduled maintenance, improper service or aftermarket calibrations.
• 10163226Jun 24, 2019Fuel system. This Bulletin provides information to correct a customer concern of a siren or whine noise from the in-tank fuel pump at temperatures below -6C or 20F, accompanied by start and stall, no start, loss of power and MIL illuminated. Technicians may find DTCs P0087, P018B, P228A, P228B or P2635 set in ECM.
• 10162150Jun 24, 2019Equipment. This Preliminary information communicates a customer concern of IPC gauges inoperative or fluctuate, No Start, No Crank, SIR Light / Service Airbag Message, Service Suspension Message, Radio display blank, Steering Wheel Controls (SWC) not illuminated, Turn Signal no audible feedback, HVAC controls inoperative.
• 10162149Jun 24, 2019Brakes. This Preliminary Information communication advises the technician that the Hydro-Boost is not serviceable and will need to be replaced if the brake pedal moves or applies on its own at a full turn.
• 10162143Jun 19, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector…
• 10164105Jun 18, 2019Equipment, Forward collision avoidance. Certain vehicles, may have incorrect language in the Forward Auto Braking (FAB) section of the owner manual which states, ?If the vehicle has Forward Collision Alert (FCA), it also has FAB which includes Intelligent Brake Assist (IBA)?. This statement is correct for light duty trucks but the heavy duty models only have the Forward Collision Alert. Customer to receive an owner manual insert. Dealers are to print and…
• 10162136Jun 17, 2019Fuel system. This Preliminary Information communication provides information to the technician for a vehicle setting both a P2635 and P018B diagnostic trouble codes. The following steps may help to determine if this is caused by a fuel pressure sensor not reading the low end of the pressure range. Technician is to make sure the engine is cold and install the Multiple Diagnostic Interface along with Global Diagnostic System 2.
• 10162127Jun 14, 2019Suspension. This Preliminary Information communication provides information to the technician about vehicle with Service ABS and/or Traction control lights/message on, Service Power Steering System, Service Suspension System, and or Loss of communication with EBCM, SWPS, PSCM, and/or SCM. Technician may find Diagnostic Trouble Codes U0077, U0121, U0126, U0131, U0139, U0401, U0415, and/or U0428. Technician should remove the…
• 10162124Jun 13, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10162108Jun 4, 2019Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that are equipped with 6L80 Regular Production Option Code (MYC), 6L90 Regular Production Option Code (MYD) or 8L90 Regular Production Option Code (M5U) Automatic Transmission, now have Powertrain Grade Braking. Powertrain grade braking assists when driving on a downhill grade to help maintain desired vehicle speed by…
• 10162106Jun 3, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10161932May 21, 2019Engine cooling. This informational bulletin advises of a new fuel injection kit used for decarbonizing the intake valves, and explains how toptier fuels should be used to reduce carbon build up.
• 10161968May 20, 2019Transmission and drivetrain. This bulletin provides information on the harmful effects of water or ethylene glycol in transmission fluid.
• 10161026May 17, 2019Fuel system. This Preliminary information communicates the location that dealers can find information to remove / delete the rear fuel tank from Chassis Cab trucks with RPO N2N dual fuel tanks.
• 10161929May 8, 2019Equipment. This warranty administration bulletin provide policy information to cover GM's policy on performing GM covered vehicle services and maintenance on vehicles originating/sold in Canada.
• 10161930May 7, 2019Tires. This warranty administration bulletin provides the information on General Motors Tire Warranty Policies and Procedures for Low Cab Forward Medium Duty Trucks (US Medium Duty Dealers Only).
• 10160987May 7, 2019Engine. This Preliminary Information communication provides information to the technician to not remove the torque converter bolts and start the engine as this may cause damage to the torque converter of the crankshaft on vehicles equipped with an automatic transmission.
• 10160983May 6, 2019Equipment, Engine. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
• 10161907May 2, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10160682Apr 23, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.
• 10165330Apr 9, 2019Equipment. This SKU is a Pitman Arm. The customer communication requested return of unsold inventory to inspect for incorrect taper of the spline. Incorrect taper of the spline prevents it from installing with the mating component, preventing installation of the part, and would therefore have no impact on the end user besides time required to complete installation.
• 10160642Apr 8, 2019Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a low voltage reading on the volt gauge during the first several minutes after a cold start. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle.
• 10160135Apr 1, 2019Equipment. This informational bulletin provides information on proper use of floor mats.
• 10160132Apr 1, 2019Electrical system. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements.
• 10158864Mar 26, 2019Equipment. This warranty administration bulletin provides information on Dealer Empowerment Labor Operations and Customer Enthusiasm.
• 10158859Mar 25, 2019Equipment. This informational bulletin provides information on interior cleaning products and what is offered to clean the interiors of GM vehicles.
• 10158855Mar 25, 2019Equipment. This informational bulletin provides the dealership with how to prep a vehicle for delivery to the customer to aid in higher CSi scores.

← All problems reported for the 2017 Chevrolet Silverado 3500