2025 Ford Ranger Engine Problems

“Complete power loss from transmission. Yes available for inspection. Power loss was experienced on at least 4 separate occasions. This occurred during either slowing down or stopping to make a left hand turn while yielding to oncoming traffic. When re-engaging the accelerator to get across oncoming traffic zero power transfer occurred putting my self, my passengers, and the oncoming vehicles and passengers at risk for a head on or Tbone collision. …”

“I was exiting the freeway, and as I was turning off of the freeway onto a side street, at approximately 20mph, my vehicle did not respond to throttle input, and left me slowing to a stop in the middle of a busy intersection. I had to shift my vehicle into neutral and then back into drive, to get it to respond to throttle input. When I slow down at intersections, turn and then attempt to throttle my vehicle, it hesitates and struggles to output power until I throttle about halfway.”

“My 2025 Ford Ranger Lariat FX4 has experienced sudden and complete loss of accelerator pedal response while driving at low speed on at least 4 to 6 separate occasions. The engine continues to run normally, but pressing the accelerator produces no power and no vehicle response. The condition has consistently occurred while pulling into my subdivision, which has an inclined entrance. The truck also feels noticeably sluggish nearly every time I make this turn, even when full dropout does not occur. …”

“I was driving my truck home on 01/22/26 and experienced a lack of acceleration and smelled oil. I got the truck home and looked under the hood. I noticed a collapsed rubber hose leading from the air intake box to the air intake of the turbo. I removed the air filter, which is practically new, and noticed no restrictions. At this point, I am trying to get it to the dealer to check for any additional problems, and replace the rubber intake hose, with something possibly better. From what I saw, the hose which has corrugations cannot handle the boost intake.”

“I am not a mechanic or a 'car person', so I may not know technical terms. This has occurred 4-6 times since purchasing the truck in March '26. After initial start up, it has a tendency to accelerate when applying the break. This is only within the first several minutes after startup. The most recent incident caused the truck to roll into the main street rather than coming to a complete stop. I was applying the break, but the truck was 'resisting' to come to a complete stop. The local Ford mechanic found this to be undesirable, but normal characteristic . …”