2015 Toyota Tacoma Technical Service Bulletins

309 technical service bulletins (TSBs) are on record for the 2015 Toyota Tacoma. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10132762Jun 12, 2014Electrical system. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW).
• 10132812May 1, 2014Engine, Back-over prevention (rear camera). Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft.
• 10131817Apr 17, 2014Equipment. 2015 model year vehicles are equipped with driver?s side floor mat retaining clips to secure the floor mat in the correct position. In addition, some models may utilize retaining clips for passenger side and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver?s side, and if applicable, the passenger?s side and rear seat floor mats to the vehicle carpet using the floor…
• 10131816Apr 16, 2014Equipment. Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for delivery. The following guidelines should be performed to minimize vehicle component/part degradation due to extended vehicle storage conditions. Long-term storage can affect a vehicle?s systems and components. Any problems that are found should be corrected immediately.
• 10131814Apr 16, 2014Wheels. During the manufacturing process tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation.
• 10131811Apr 11, 2014Equipment. The radio antenna pole on some models is designed with a hex-cut base and requires installation using an 8 mm wrench. When performing PDS or installing the antenna pole for any other reason, inspect the antenna base for a hex-cut to determine if the following procedure is required.
• 10060709Apr 11, 2014Equipment. Summary to be provided on a future date.
• 10197476May 4, 2001Equipment. Replacement vin plates.
• 10197473Jan 18, 1991Equipment. Product general information.

← All problems reported for the 2015 Toyota Tacoma