2009 Toyota Venza Technical Service Bulletins

207 technical service bulletins (TSBs) are on record for the 2009 Toyota Venza. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10132156Sep 13, 2013Equipment. If a customer states there is an unpleasant odor in the vehicle from the HVAC system, there are various factors that may be involved.
• 10062013Sep 13, 2013Equipment. Summary to be provided on a future date.
• 10131985Sep 12, 2013Equipment. Some 2004 ? 2014 model year Toyota vehicles may exhibit odors naturally occurring from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced.
• 10131984Sep 9, 2013Equipment, Brakes. A new Special Service Tool (SST 09709-00002) has been introduced to aid in the inspection procedure for certain vehicles equipped with a floor pedal-type parking brake system. This bulletin references the correct method for installing the Brake Pedal Force Gauge. Refer to the appropriate Repair Manual for parking brake pedal travel inspection and adjustment specification.
• 10131983Sep 6, 2013Seat belts. The customer (individual requiring the extender) must visit a Toyota dealership to have the required measurements made and to complete the Seat Belt Extender Worksheet. The worksheet will allow the proper fitting and selection of a Seat Belt Extender for the customer. The dealership personnel should then determine the applicable part number and place an order through Dealer Daily
• 10132202Aug 8, 2013Back-over prevention (rear camera). Some vehicles may exhibit a MIL ?ON? Diagnostic Trouble Code (DTC) P0138 and/or P0158 (Oxygen Sensor Circuit High Voltage Bank 1 or 2). In some instances a P2195 or P2197 (A/F Sensor Signal Stuck Lean) DTC may also be present. This condition may be caused by incorrect Air Fuel Ratio Sensor response. Additionally, a P0606 (ECM/PCM Processor) DTC may be present due to incorrect Oxygen Sensor operation. The following…
• 10054869Aug 8, 2013Engine. Toyota: updated information regarding the response of the air fuel ratio sensor, that is incorrect and also, an incorrect oxygen sensor operation may be present, due to ecm/pcm processor p0606 dtc.
• 10062051Aug 1, 2013Equipment. Summary to be provided on a future date.
• 10132269Jul 25, 2013Visibility (wipers, defrost, mirrors). Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields.
• 10062053Jul 25, 2013Body and structure. Summary to be provided on a future date.
• 10132048May 22, 2013Tires. Please refer to the following recommendations for the best practices for vehicle tire rotations.
• 10062016May 22, 2013Tires. Summary to be provided on a future date.
• 10132045May 3, 2013Electrical system. Some customers may complain that the Rear Seat Entertainment (RSE) system is inoperative if the have misplaced the parental passcode for the system.
• 10132320Apr 23, 2013Seats, Electrical system. Some customers may complain that the Rear Seat Entertainment (RSE) system is inoperative if they have misplaced the parental passcode for the system.
• 10132295Apr 23, 2013Equipment. This bulletin is now obsolete. Please see T-SB-0054-13.
• 10132287Apr 23, 2013Equipment. California (CA), Federal (FED), and 50 State Certified emission control underhood labels (emission labels) may be obtained through your dealership?s Parts Department utilizing standard replacement parts ordering procedures. Follow the guidelines outlined in this bulletin to ensure proper label application.
• 10132281Apr 4, 2013Body and structure, Back-over prevention (rear camera). If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area.
• 10133796Mar 15, 2013Equipment. This bulletin is now obsolete. Please see T-SB-0041-13 .
• 10133786Mar 15, 2013Engine. Immediately following a cold soak startup, some 2009 ? 2013 model year vehicles equipped with 1AR-FE or 2AR-FE engines may exhibit a brief knock/rattle noise from the engine compartment for approximately one second. Follow the repair procedure below to address this condition.
• 10061557Mar 15, 2013Engine. Summary to be provided on a future date.
• 10054846Mar 15, 2013Engine. Toyota: on certain vehicles, a knock or rattle noise, coming from engine compartment, is heard during a cold soak startup, and the condition lasts approximately one second. Model years 2009-2012 camry, highlander, sienna, venza, rav4.
• 10053959Mar 15, 2013Engine. Toyota: there is a knocking or rattling noise coming from engine compartment, for a short period of time, after a cold soak startup. Model 2010-2012 camry, 2009-2013 highlander, venza, 2009-2012 rav4, 2011-2013 sienna.
• 10133860Feb 27, 2013Electrical system. The customer is having difficulty changing the multi-display screen from Day Mode. If the multi-display screen is set to Day Mode when the headlights are on, the setting we be memorized when the engine is turned off.
• 10133875Feb 25, 2013Equipment. Toyota will be sending Safety Recall Follow-up notices to remind owners whose vehicles have not yet had campaign repairs completed
• 10133874Feb 25, 2013Equipment. Toyota will be sending Safety Recall Follow-up notices to remind owners whose vehicles have not yet had campaign repairs completed
• 10133857Feb 25, 2013Steering. The vehicle will not start or ready-on and the steering wheel lock is engaged so that the steering wheel may only be turned very little from side-to-side.
• 10133835Feb 19, 2013Equipment. Some customers may inquire about the frequency and power output of the Smart Key/Smart Entry systems used on various models. The Smart Key/Smart Entry systems conform to all applicable FCC rules. This bulletin details the applicable specifications for these systems.
• 10061549Feb 19, 2013Electrical system. Summary to be provided on a future date.
• 10133899Jan 31, 2013Steering. Some 2009 ? 2013 model year Venza vehicles may exhibit a ?pop? noise from the steering column when turning the steering wheel sharply during low speed maneuvers. Perform the repair procedure outlined in this bulletin to address this condition.
• 10060843Jan 31, 2013Steering. Summary to be provided on a future date.
• 10133928Jan 29, 2013Equipment. This communication pertains to a current safety recall being conducted by the Southeast Toyota Distributors LLC (SET). TMS is sending this communication for informational purposes in the event you are contacted by a customer covered by this recall.
• 10133901Jan 29, 2013Equipment. This bulletin is now obsolete. Please see T-SB-0012-13.
• 10133897Jan 29, 2013Electrical system. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the TIS and the CUW.
• 10133891Jan 14, 2013Engine. Some 2009 ? 2013 model year Venza vehicles equipped with 2GR-FE engines may exhibit difficulty restarting in sub-freezing temperatures (approximately ?4 F [?20 C] and lower).
• 10051814Jan 14, 2013Electrical system, Engine. Toyota: after being in sub freezing temperatures, vehicles engine may have difficulty in re-starting, after short trips or after using remote engine starting (res) system. Models 2009-2013 venza.
• 10133915Jan 3, 2013Air bags. Toyota vehicles are equipped with SRS, including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pretensioner devices did not perform as expected, please follow the steps in the recommendations section below.
• 10133878Jan 2, 2013Electrical system. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates…
• 10133996Oct 22, 2012Engine. Some 2010 ? 2011 model year Camry vehicles equipped with the 2AR-FE engine and some 2009 ? 2013 model year Venza vehicles equipped with the 1AR-FE engine may exhibit one or more of the following conditions: A/C inoperative while the vehicle is stopped. Rising engine temperature while the vehicle is stopped.
• 10061660Oct 22, 2012Engine cooling. Summary to be provided on a future date.
• 10133974Oct 4, 2012Body and structure. Toyota vehicles are equipped with either conventional or run-flat tires. Sometimes punctures may occur as a result of contact with road debris or other hazards. If a puncture occurs, it may be possible to repair the tire and return it to service. With a conventional tire it is not possible to drive for an extended amount of time with the tire at low pressures as damage to the tire may occur.
• 10061649Oct 4, 2012Tires. Summary to be provided on a future date.
• 10045140Jun 13, 2012Vehicle speed control. Toyota: accelerator pedal sensor assembly information regarding the inspection, removal, and installation, if lubrication or oil, is applied.
• 10052153Feb 2, 2012Brakes. Toyota: some vehicles may exhibit a warning light on condition for abs/vsc. Model 2009-2011 venza.
• 10042892Dec 21, 2011Engine cooling. Toyota: on some vehicles, the engine oil cooler pipes may exhibit an oil seepage. Information has been provided regarding this issue.
• 10042555Sep 6, 2011Air bags, Seats. Toyota: information provided for replacing the seat covers for vehicles equipped with side airbags.
• 10033553Mar 1, 2011Engine cooling, Transmission and drivetrain. Toyota service campaign: see document search button for owner letter. Vehicles equipped with a 2gr-fe (v6) engine, the rubber portion of the oil supply hose for vvt-I actuator may degrade over time. This condition may cause oil to leak from the vvt-I oil hose producing abnormal engine noise and the oil pressure light to illuminate.
• 10037886Jan 6, 2011Steering. Toyota: there is a rattle noise from the power steering column when turning or driving on rough roads. 2009-2011 venza.
• 10034924Jun 9, 2010Engine cooling. Toyota: brief engine knock/rattle noise cold startup. Immediately following a cold soak startup, some model vehicles equipped with the 1ar-fe and 2ar-fe engines may exhibit a brief knock/rattle noise from the engine compartment for approximately one second. *pe updated 9/28/11.
• 10034193Feb 17, 2010Steering. Toyota: steering column. Some vehicles may exhibit a popping noise from the steering column when the steering wheel is rotated to the left or right steering stop.
• 10034284Feb 4, 2010Engine cooling. Toyota: techstream ecu flash reprogramming procedure. Flash reprogramming allows the ecu software to be updated without replacing the ecu. Flash calibration updates for specific vehicle models/ecus are released as field-fix procedures described in individual service bulletins. Model years from 2001-2011.

← All problems reported for the 2009 Toyota Venza