2013 Audi A3 Technical Service Bulletins

864 technical service bulletins (TSBs) are on record for the 2013 Audi A3. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10124888Dec 8, 2014Equipment. Supersedes Technical Service Bulletin Group 44 number 14-50 dated May 14, 2014. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. Customer feels the vibration while driving at highway speeds from 55 ? 80 mph (88 ? 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10124898Dec 4, 2014Equipment. This is an advance notice for Audi of America employees. This notice contains information for the accessories operations technical bulletin.
• 10228379Nov 25, 2014Engine cooling. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
• 10225058Nov 25, 2014Engine cooling. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
• 10222031Nov 25, 2014Engine cooling. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
• 10124866Nov 25, 2014Engine. Supersedes Technical Service Bulletin Group 01 number 13-29 dated September 16, 2013. The engine warning light is on after engine replacement. The engine is not running roughly. However, the engine control module, J623 (address word 01), is storing one or more engine misfire fault codes. The fault codes occur at light load, between 8% and 14% accelerator pedal position. The programmed values for the misfiring…
• 10216674Nov 18, 2014Engine cooling, Fuel system. A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
• 10124868Nov 18, 2014Engine cooling. A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
• 10231142Nov 17, 2014Equipment. Technical bulletins and updates
• 10124867Nov 7, 2014Engine. Supersedes Technical Service Bulletin Group 17 number 14-50 dated August 15, 2014. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
• 10057306Nov 7, 2014Electrical system. Volkswagen: 2011-2013 information on replacement of the tipm software. This software controls the tipm operation & front exterior lighting of the vehicle.
• 10124877Nov 4, 2014Electrical system. The following message appears on the MMI display: ?Device or cable type not supported?. The ?Device or cable type not supported? message may be displayed when the wrong AMI cable type is used. See the Service section of this bulletin for an overview of the AMI cables that support iOS devices.
• 10231140Nov 3, 2014Equipment. Technical bulletins and updates
• 10226412Oct 30, 2014Electrical system. Remove key warning in DIS, MMI does not turn off with key removed, or locking with remove does not work
• 10124738Oct 30, 2014Electrical system. The infotainment system (radio, navigation, etc.) is not switched off when the ignition key is removed. The steering column cannot be locked. The vehicle cannot be locked with the remote. A warning appears in the DIS indicating that the key must be removed from the ignition, but the key has already been removed. DTCs may be logged in the onboard supply control module. The locking cylinder for the ignition lock is…
• 10250950Oct 21, 2014Wheels. Tightening wheel bolts
• 10250949Oct 21, 2014Steering. Steering wheel leather damage, all vehicles
• 10124754Oct 21, 2014Steering. Supersedes Technical Service Bulletin Group 48 number 13-54 dated September 13, 2013. Steering wheel appearance damaged due to external impact (e.g., contact with finger nails, zippers, watches, rings, etc.). External impact (e.g., contact with finger nails, zippers, watches, rings etc.) can cause damage to the appearance of the steering wheel. This type of damage is not warrantable, as numerous investigations have…
• 10124760Oct 17, 2014Equipment. Supersedes Technical Service Bulletin Group 87 number 13-46 dated October 21, 2013. The A/C Compressor has been diagnosed as faulty and will be replaced under warranty. When performing replacement of an A/C Compressor under warranty, the amount of refrigerant and oil recovered must be documented.
• 10124745Oct 16, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 14-24 dated January 24, 2014. The Audi MMI system will not play audio files from an SD card. The MMI system does not recognize the audio files on the SD card. The MMI system reports that the audio files on the SD card are damaged. The audio files on the SD card will play on one Audi vehicle, but will not play on a different Audi vehicle. The vehicle is equipped…
• 10124744Oct 16, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 13-85 dated May 29, 2013. The iPod or the USB memory stick is not recognized or the iPod is not charged when either unit is connected to the Audi music interface (AMI). MMI3G or a Symphony/Concert CAN radio system with separate AMI control unit in the glove box or armrest. MMI3G+ with integrated AMI in the MMI main unit.
• 10216633Oct 15, 2014Equipment. The programmed values for the misfire adaption are not automatically reset when the memory is deleted. The adaption must be reset after the engine is installed.
• 10243757Oct 13, 2014Equipment. Audi Elsa Newsletter
• 10067708Oct 13, 2014Equipment. Summary to be provided on a future date.
• 10124751Oct 12, 2014Wheels. Supersedes Technical Service Bulletin Group 44 number 13-46 dated December 9, 2013. Wheel bolt requires torque adjustment.
• 10243756Oct 6, 2014Equipment. Audi Elsa Newsletter
• 10216690Oct 6, 2014Fuel system. Beginning with MY2009, the filler necks of various TDI clean diesel vehicles were equipped with a misfueling guard (Figure 1). The guard minimizes the likelihood that fuel other than ultra-low sulfur diesel will be put into the vehicle. The misfueling guard is designed to remain in a locked position when a nozzle with a diameter typically suited for non-diesel fuels (approximately 13/16?, or 20.6mm) is inserted, to…
• 10124720Oct 6, 2014Fuel system. Supersedes Technical Service Bulletin Group 20 number 13-26 dated May 15, 2013. Customer states that the vehicle cannot be refueled due to difficulty inserting the fuel pump nozzle into the filler neck. Customer may also state that the flap is stuck in a locked position and it cannot be moved with fingers.
• 10065970Oct 6, 2014Fuel system. Summary to be provided on a future date.
• 10124763Oct 2, 2014Electrical system, Equipment. Supersedes Technical Service Bulletin Group 91 number 13-08 dated September 20, 2013. The customer would like to add a different navigation map database for countries outside of the USA or Canada. The customer would like to change the MMI system language to a different language that is not already supported by MMI.
• 10124764Oct 1, 2014Equipment. The audio CD or navigation DVD cannot be ejected from the RNS-E optical disc slot behind the navigation screen. The adaptation for enabling the eject button was either not performed at PDI or was not performed correctly (with a bus sleep immediately following the adaptation change). If ODIS OBD self-diagnosis was used, then it's possible a value of "1" was used, or if using the GFF test plan, the "CD/DVD Ejecting"…
• 10066409Oct 1, 2014Equipment. Summary to be provided on a future date.
• 10124806Sep 23, 2014Visibility (wipers, defrost, mirrors). Windshield is streaked, has a snakeskin appearance, or its surface feels rough. Residue from industrial fallout as well as normal road dirt and grime may accumulate on windshield.
• 10243763Sep 22, 2014Equipment. Audi Elsa Newsletter
• 10067714Sep 22, 2014Electrical system. Summary to be provided on a future date.
• 10124798Sep 12, 2014Visibility (wipers, defrost, mirrors). Supersedes Technical Service Bulletin Group 92 number 14-08 dated August 19, 2014. The washer solvent level warning is on in the DIS, but the washer solvent level is correct. There is no functional restriction in the windshield washer system. The sensitivity of the washer solvent level sensor (G33) can be affected by the type, concentration, and the presence of additives in the washer solvent currently in the tank.
• 10216628Sep 10, 2014Engine cooling. Customer vehicle is fitted with unauthorized ECM tuning.
• 10124823Sep 10, 2014Equipment. Customer vehicle is fitted with unauthorized ECM tuning. All systems on Audi vehicles are engineered to work together using the factory calibrations, which have been extensively tested and validated before the vehicle is released for sale. The Audi warranty coverage is based on the results of developing the vehicle under the factory calibration.
• 10243761Sep 8, 2014Equipment. Audi Elsa Newsletter
• 10216652Aug 15, 2014Engine cooling. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
• 10122524Jul 31, 2014Equipment. Supersedes Technical Service Bulletin Group 00 number 14-61 dated May 1, 2014. Technician preparation when calling the Audi Technical Assistance Center (TAC).
• 10228298Jul 30, 2014Engine cooling. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated.
• 10224977Jul 30, 2014Engine cooling. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated.
• 10221950Jul 30, 2014Equipment. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated.
• 10122523Jul 30, 2014Electrical system. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated. This DTC is normal. It indicates that the parameter data has not been properly programmed into the ECU by SVM.
• 10231144Jul 28, 2014Equipment. Technical bulletins and updates
• 10231126Jul 28, 2014Electrical system. i-wire new wiring diagram application
• 10122555Jul 18, 2014Electrical system. Supersedes Technical Service Bulletin Group 57 number 13-97 dated October 29, 2013. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle ?locked itself?. The lock command history is stored in the convenience system control module (J393).
• 10228297Jul 15, 2014Electrical system. This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update.
• 10224976Jul 15, 2014Back-over prevention (rear camera). This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update.

← All problems reported for the 2013 Audi A3