2011 Audi Q7 Technical Service Bulletins

1,053 technical service bulletins (TSBs) are on record for the 2011 Audi Q7. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10066955Jul 18, 2013Body and structure. Summary to be provided on a future date.
• 10124525Jul 16, 2013Equipment, Electrical system. Supersedes Technical Service Bulletin Group 91 number 12-61 dated September 25, 2012. The customer complains that when he or she is trying to place a phone call from the vehicle while using a Bluetooth®-connected phone, the phone call disconnects before it begins and an error shows on the MMI display. The message may be "Function not supported" or "Network error". The customer is using a phone with the Android…
• 10124577Jul 12, 2013Electrical system. Supersedes Technical Service Bulletin Group 94 number 13-17 dated May 22, 2013. DTC 03073 (Closed Rear Lid Sensor - Incorrect Signal) may be stored in the comfort system central control module, J393 (address word 46). In order for the vehicle to receive a proper rear lid status signal when the lid is operated, the paddle switches on the rear sill trim must contact the opposing lid latch points uniformly.
• 10124573Jul 12, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 13-64 dated June 20, 2013. The customer is able to program one or more of the Homelink buttons using their garage door remote, but after a few days or weeks, one or more of the programmed Homelink buttons no longer functions. The LED on the Homelink button that is no longer functioning now flashes slowly, indicating that no programming is stored. The customer's…
• 10068713Jul 12, 2013Body and structure. Summary to be provided on a future date.
• 10066985Jul 12, 2013Body and structure. Summary to be provided on a future date.
• 10124574Jul 10, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 12-37 dated June 11, 2012. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer's door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener…
• 10124505Jul 8, 2013Brakes, Electrical system. Customer may report sporadically hearing the parking brake being actuated after the vehicle has been switched off. If the customer does not identify the sound as the sound of the parking brake being actuated, he or she may simply complain of hearing noises from the rear brakes. Ignition is switched off. Steering is locked. Park is selected. Parking brake is not engaged.
• 10124580Jul 3, 2013Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 13-11 dated March 6, 2013. There is considerable moisture present in the headlamp. The moisture disappears only after extended drives (greater than 10 minutes). There is no external damage to the headlamp which could introduce moisture. Humid air settles on the inside of the glass, causing moisture to appear on the inside of the headlamp lens. Because of the…
• 10068710Jul 3, 2013Exterior lighting. Summary to be provided on a future date.
• 10243787Jul 1, 2013Equipment. Audi Elsa Newsletter
• 10228314Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10224993Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10221966Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10123591Jun 21, 2013Fuel system, Electrical system. Supersedes Technical Service Bulletin Group 00 number 10-01 dated February 5, 2010. Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. Engine runs rough after cold start. Excessive engine cranking time. Hesitations while driving. Rough engine idle. Reduced engine performance. Poor fuel economy.
• 10123587Jun 20, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-35 dated March 25, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10123558Jun 20, 2013Electrical system. Supersedes Technical Service Bulletin Group 96 number 12-32 dated April 27, 2012. The customer is able to program one or more of the Homelink buttons using their garage door remote, but after a few days or weeks, one or more of the programmed Homelink buttons no longer function. The LED on the Homelink button that is no longer functioning now flashes slowly, indicating that no programming is stored. The customer?s…
• 10123559Jun 19, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 10-68 dated October 26, 2010. The MMI control knob joystick is loose or has fallen off. Only vehicles with navigation and without MMI touch are affected.
• 10123563Jun 12, 2013Lane departure, Visibility (wipers, defrost, mirrors). Supersedes Technical Service Bulletin Group 66 number 13-28 dated April 10, 2013. The customer may report hearing wind noise while driving at highway speeds. The noise may occur on either side of the vehicle. Wind noise may be coming from either the mirror base or the lane change assist lamp. Improved parts are available.
• 10243793Jun 10, 2013Equipment. Audi Elsa Newsletter
• 10243792Jun 3, 2013Equipment. Audi Elsa Newsletter
• 10228306May 29, 2013Engine cooling. Under certain driving conditions, the secondary air ports in the cylinder head can accumulate carbon over time, causing a restriction.
• 10224985May 29, 2013Engine cooling. Under certain driving conditions, the secondary air ports in the cylinder head can accumulate carbon over time, causing a restriction.
• 10221958May 29, 2013Engine cooling. Under certain driving conditions, the secondary air ports in the cylinder head can accumulate carbon over time, causing a restriction.
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10124944May 29, 2013Equipment. Supersedes Technical Service Bulletin Group 01 number 13-83 dated March 29, 2013. MIL on. DTCs are stored in the engine control module. Mileage is greater than 15,000 miles. Under certain driving conditions, the secondary air ports in the cylinder head can accumulate carbon over time, causing a restriction.
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10068707May 22, 2013Exterior lighting. Summary to be provided on a future date.
• 10052245May 22, 2013Exterior lighting. Audi: on some vehicles, the switch between rear lid tail lamp and bumper, does not switch over when lid is in operation, due to paddle, of rear sill trim, not contacting opposing lid latch points, uniformly. Models 2007-2014 q7, 2009-2014 q5. *pe updated 07/10/2013
• 10243994May 20, 2013Other or unknown. Elsaweb Newsletter
• 10228305May 20, 2013Engine cooling. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10224984May 20, 2013Transmission and drivetrain, Electrical system. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10221957May 20, 2013Transmission and drivetrain. Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10124943May 20, 2013Electrical system. Supersedes Technical Service Bulletin Group 26 number 12-14 dated August 31, 2012. MIL on. DTCs is stored in the engine control module (ECM). Moisture ingress due to inadequate internal sealing of some differential pressure sensors (G505) causes electronic failure of the sensors. Part analysis shows that this condition only affects parts that were produced on or before March 29, 2011.
• 10065349May 20, 2013Engine. Summary to be provided on a future date.
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10243993May 13, 2013Equipment. Elsaweb Newsletter
• 10228372May 13, 2013Fuel system, Electrical system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10225051May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10222024May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10124956May 13, 2013Electrical system. Supersedes Technical Service Bulletin Group 01 number 13-79 dated March 20, 2013. MIL on. DTCs are stored in the engine control module (address word 01). Excess rattling (?diesel clatter?) coming from engine. No start or hard starting condition. Contaminated fuel found in fuel system. Rust or metal debris found in fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery…
• 10065701May 13, 2013Fuel system. Summary to be provided on a future date.
• 10052350May 13, 2013Engine. Audi: some vehicle may experience coolant loss. The malfunction indicator lamp is on.
• 10052289May 13, 2013Fuel system, Engine. Audi: the rail fuel pressure is too high. Fuel may be contaminated by rust or metal debris.
• 10251012May 8, 2013Suspension. Vehicle lowers itself, air suspension warning light on, level sensor error (PR-2MB or 1BK)
• 10251010May 8, 2013Suspension. Vehicle lowers itself, air suspension warning light on, software outdated (PR-2MB or 1BK)
• 10250679May 8, 2013Suspension, Air bags, Back-over prevention (rear camera), Lane departure…. Vehicle lowers itself, air suspension warning light on, level sensor error (PR-2MB or 1BK)

← All problems reported for the 2011 Audi Q7