2013 Audi Q7 Technical Service Bulletins

1,239 technical service bulletins (TSBs) are on record for the 2013 Audi Q7. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10231133Mar 17, 2014Equipment. Technical bulletins and updates
• 10226436Mar 13, 2014Electrical system. 97 No start (DTC P068A00)
• 10216609Mar 13, 2014Brakes. Updated oil pressure switch
• 10122279Mar 13, 2014Engine cooling. The MIL is on. DTC P164B(00) is stored in the ECM. The oil pressure switch is defective.
• 10122297Mar 11, 2014Engine cooling. Supersedes Technical Service Bulletin Group 80 number 13-05 dated September 11, 2013. Malfunction Indicator Lamp is on. Climate system heating performance is insufficient. Coolant level warning is on. Engine temperature is elevated. "Limp Home" mode is active. Faults are stored in the transmission control module (address word 02). Coolant loss is found from one or more control valves: N82, N509, or N488.
• 10228399Mar 6, 2014Fuel system, Engine cooling. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10225078Mar 6, 2014Fuel system. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10222051Mar 6, 2014Fuel system. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10122301Mar 6, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 14-26 dated February 24, 2014. The MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when a phone is connected to the vehicle via Bluetooth when the user searches for a contact name in the MMI address book (by using the MMI control knob or the voice recognition system).
• 10122277Mar 6, 2014Fuel system. The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10122300Mar 4, 2014Equipment, Electrical system. The addresses and contacts stored in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus disappear intermittently in vehicles with MMI3G+ Navigation, and in vehicles with or without Audi connect. Intermittently, the MMI system does not appear to remember that the user's myAudi PIN has already been entered, and it requires the user to enter the PIN again in vehicles…
• 10066861Mar 1, 2014Steering. Summary to be provided on a future date.
• 10055710Mar 1, 2014Electrical system. Gearbox warning light malfunction. 07/09/2014
• 10125561Feb 27, 2014Equipment. Supersedes Technical Service Bulletin Group 87 number 12-27 dated April 24, 2012. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor.
• 10125564Feb 24, 2014Seats. The MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when the user searches for a contact name in the MMI address book when a phone is connected to the vehicle via Bluetooth. This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact.
• 10228292Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10221944Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10125536Feb 20, 2014Electrical system. Supersedes Technical Service Bulletin Group 00 number 12-34 dated June 6, 2012. The process of draining oil through the drain plug is not always tidy. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10231119Feb 17, 2014Equipment. Technical bulletins and updates
• 10228395Feb 4, 2014Electrical system, Engine cooling. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10225074Feb 4, 2014Engine cooling. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10222047Feb 4, 2014Engine cooling. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10125578Feb 4, 2014Engine. Supersedes Technical Service Bulletin Group 01 number 14-58 dated January 14, 2014. The MIL is on. DTCs are stored in the ECM. Drivability is not affected. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any…
• 10065706Feb 4, 2014Engine. Summary to be provided on a future date.
• 10231117Feb 3, 2014Equipment. Technical bulletins and updates
• 10231123Jan 27, 2014Equipment. Technical bulletins and updates
• 10228392Jan 24, 2014Fuel system, Engine cooling. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10225071Jan 24, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10222044Jan 24, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10122204Jan 24, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 09-30 dated April 14, 2009. The Audi MMI system will not play audio files from an SD card. The MMI system does not recognize the audio files on the SD card. The MMI system reports that the audio files on the SD card are damaged. The audio files on the SD card will play on one Audi vehicle, but will not play on a different Audi vehicle.
• 10122183Jan 24, 2014Engine. Supersedes Technical Service Bulletin Group 01 number 14-59 dated January 21, 2014. The MIL is on. DTC may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.
• 10065426Jan 24, 2014Engine. Summary to be provided on a future date.
• 10251028Jan 21, 2014Steering. Alignment - Repair Authorization
• 10228390Jan 21, 2014Engine cooling. One of the vacuum actuators on intake runner bank 1 or bank 2 is defective. It is possible that the membrane on the vacuum actuator may tear. As a result, the intake manifold flaps do not function.
• 10228389Jan 21, 2014Fuel system, Engine cooling. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10225069Jan 21, 2014Engine cooling. One of the vacuum actuators on intake runner bank 1 or bank 2 is defective. It is possible that the membrane on the vacuum actuator may tear. As a result, the intake manifold flaps do not function.
• 10225068Jan 21, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10222042Jan 21, 2014Engine cooling. One of the vacuum actuators on intake runner bank 1 or bank 2 is defective. It is possible that the membrane on the vacuum actuator may tear. As a result, the intake manifold flaps do not function.
• 10222041Jan 21, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10122189Jan 21, 2014Wheels, Steering. Supersedes Technical Service Bulletin Group 44 number 13-39 dated July 12, 2013. Vehicle pulls (left or right). Steering wheel is not level or is off-center. These conditions may be noticed during PDI. If the condition is due to outside influence (such as an accident), this TSB does not apply. In an effort to gain information on this condition, Audi of America is asking you to contact the Audi Technical Assistance…
• 10122181Jan 21, 2014Transmission and drivetrain, Engine, Brakes. Supersedes Technical Service Bulletin Group 01 number 13-34 dated October 8, 2013. The MIL is on. DTCs are stored in the ECM. There may be slight power reduction at high RPMs. One of the vacuum actuators on intake runner bank 1 or bank 2 is defective. It is possible that the membrane on the vacuum actuator may tear. As a result, the intake manifold flaps do not function.
• 10122180Jan 21, 2014Engine. Supersedes Technical Service Bulletin Group 01 number 14-55 dated January 8, 2014. The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.
• 10065424Jan 21, 2014Engine. Summary to be provided on a future date.
• 10065423Jan 21, 2014Electrical system, Engine. Summary to be provided on a future date.
• 10231122Jan 20, 2014Equipment. Technical bulletins and updates
• 10228388Jan 14, 2014Electrical system. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10225067Jan 14, 2014Electrical system, Engine cooling. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10222040Jan 14, 2014Fuel system, Engine cooling. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any pressure drop within a specified amount of time in order to detect a leak.
• 10122179Jan 14, 2014Electrical system, Engine. Supersedes Technical Service Bulletin Group 01 number 13-40 dated November 4, 2013. The MIL is on. DTCs are stored in the ECM. Drivability is not affected. The leak detection pump (LDP) is a vacuum-driven, ECM-controlled, diaphragm pump. In order for the LDP to operate, the engine must be running and vacuum must be applied to the vacuum switch on the LDP. The LDP pressurizes the EVAP system and monitors any…
• 10065422Jan 14, 2014Engine cooling, Electrical system. Summary to be provided on a future date.

← All problems reported for the 2013 Audi Q7