2009 Audi TT Technical Service Bulletins

489 technical service bulletins (TSBs) are on record for the 2009 Audi TT. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10216652Aug 15, 2014Engine cooling. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
• 10122524Jul 31, 2014Equipment. Supersedes Technical Service Bulletin Group 00 number 14-61 dated May 1, 2014. Technician preparation when calling the Audi Technical Assistance Center (TAC).
• 10228298Jul 30, 2014Engine cooling. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated.
• 10221950Jul 30, 2014Equipment. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated.
• 10122523Jul 30, 2014Electrical system. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated. This DTC is normal. It indicates that the parameter data has not been properly programmed into the ECU by SVM.
• 10231144Jul 28, 2014Equipment. Technical bulletins and updates
• 10231126Jul 28, 2014Electrical system. i-wire new wiring diagram application
• 10216620Jul 17, 2014Back-over prevention (rear camera), Brakes. Assistance to properly diagnose a fuel pressure sensor -G247- concern.
• 10122526Jul 17, 2014Fuel system. Supersedes Technical Service Bulletin Group 01 number 11-32 dated October 26, 2011. The MIL is on. DTCs may be stored in the ECM. Assistance to properly diagnose a fuel pressure sensor -G247- concern.
• 10228297Jul 15, 2014Electrical system. This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update.
• 10221949Jul 15, 2014Equipment. This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update.
• 10122522Jul 15, 2014Electrical system. Supersedes Technical Service Bulletin Group 00 number 12-32 dated February 7, 2012. This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update.
• 10250966Jul 14, 2014Brakes. Brake pulsation diagnostic guidelines
• 10231125Jul 14, 2014Equipment. Pending service solutions and bulletins
• 10128242Jul 14, 2014Suspension, Brakes, Air bags. Brake-related vibration and pulsation has several causes that depend on driving style and resulting brake disc temperature, as well as environmental conditions. Both the intensity of the wear of the brake system and the type of wear depend on the operating conditions of the vehicle. The wear of the brake discs is determined by the frequency and intensity of the brake operations.
• 10249054Jul 10, 2014Other or unknown. Due to new Minnesota state regulations regarding biofuels, biodiesel blends of B5 or less may not be available in the State of Minnesota.
• 10122563Jul 10, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 13-02 dated August 30, 2013. Customer may report that cracking, grinding, rattling, humming, whining, or similar interference is coming from one or more speakers. Parts of the speakers (such as the brackets, cables, or covers) or parts of the interior fittings (such as door covers, rear shelf, facings, or covers) can vibrate at certain frequencies, causing noises.
• 10250963Jul 9, 2014Steering. Loud cracking or rubbing noises when steering (vehicles without Audi magnetic ride suspension)
• 10250673Jul 9, 2014Steering. Loud cracking or rubbing noises when steering (vehicles without Audi magnetic ride suspension)
• 10122542Jul 9, 2014Steering. Supersedes Technical Service Bulletin Group 42 number 12-16 dated November 13, 2012. Loud cracking or rubbing noises are heard when the steering wheel is being turned. Steering is not affected and operates normally. This bulletin does not apply to vehicles with magnetic ride suspension (which are equipped with rubber shock absorber stop and a plastic cap on the shock).
• 10066027Jul 9, 2014Suspension. Summary to be provided on a future date.
• 10250959Jul 2, 2014Suspension. Shock absorber leaks: assessment aid
• 10250958Jul 2, 2014Steering. Squeaking noises when steering or maneuvering
• 10250665Jul 2, 2014Body and structure, Equipment. Shock absorber leaks: assessment aid
• 10250664Jul 2, 2014Steering. Squeaking noises when steering or maneuvering
• 10122540Jul 2, 2014Suspension. Supersedes Technical Service Bulletin Group 40 number 13-34 dated September 23, 2013. Oil appears on one or several shock absorbers.
• 10122539Jul 2, 2014Steering. Supersedes Technical Service Bulletin Group 40 number 13-35 dated September 23, 2013. Squeaking noises are heard when the steering wheel is turned or maneuvered. The noises may be more prevalent in wet weather. The folds of the outer rubber boots on the front axle shafts may come in contact with each other when the steering wheel is turned, causing squeaking noises. These noises are more likely to occur when the…
• 10231130Jun 30, 2014Engine cooling. Idenifying and mixing factory fill engine coolants
• 10122415Jun 20, 2014Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-41 dated June 20, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10231127Jun 9, 2014Equipment, Electrical system. ElsaPro Software update and technical bulletins
• 10212703May 29, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10228295May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10226529May 28, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10221947May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10210679May 28, 2014Electronic stability control, Transmission and drivetrain. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system…
• 10122465May 28, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-07 dated May 29, 2013. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off). No DTCs are stored. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left…
• 10122452May 28, 2014Engine, Equipment. Supersedes Technical Service Bulletin Group 00 number 13-49 dated May 14, 2013. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating…
• 10231139May 26, 2014Equipment. Technical bulletins and updates
• 10250971May 14, 2014Steering. Steering wheel shimmy, vibration, and/or oscillation
• 10122467May 14, 2014Suspension, Steering. Supersedes Technical Service Bulletin Group 44 number 14-49 dated April 17, 2014. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 ? 80 mph (88 ? 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10249085May 13, 2014Other or unknown. Google Maps Street View (NVLW))
• 10231108Apr 28, 2014Electrical system, Engine cooling. 97 no start
• 10250982Apr 17, 2014Steering. Steering wheel shimmy, vibration, and/or oscillation
• 10122338Apr 17, 2014Suspension. Supersedes Technical Service Bulletin Group 44 number 13-44 dated November 21, 2013. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 - 80 mph (88 - 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10250106Apr 14, 2014Equipment. Elsa newsletter
• 10226433Apr 14, 2014Electrical system. 97 No start (DTC P068A00)
• 10122370Apr 14, 2014Electrical system. Supersedes Technical Service Bulletin Group 97 number 14-42 dated March 31, 2014. The MIL is on. Vehicle will not start. DTC P068A00 is stored in the ECM. The motronic engine control module power supply relay, J271, is not functioning properly. Because the J271 relay controls battery voltage (Terminal 30) via a ground signal sent from the ECM, numerous faults can occur in multiple control modules when it is not…
• 10122359Apr 10, 2014Electrical system, Equipment. Supersedes Technical Service Bulletin Group 91 number 13-92 dated July 16, 2013. The customer complains that when he or she is trying to place a phone call from the vehicle while using a Bluetooth®-connected phone, the phone call disconnects before it begins and an error shows on the MMI display. The message may be "Function not supported" or "Network error". The customer is using a phone with the Android operating…
• 10122357Apr 8, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 14-19 dated January 3, 2014. Customer complains that during Bluetooth calls, the person at the other end has trouble hearing the speaker in the vehicle. Voice recognition accuracy is poor. This TSB provides guidelines for testing microphones in a vehicle.
• 10231131Apr 3, 2014Equipment. Technical bulletins and updates

← All problems reported for the 2009 Audi TT