2012 Honda Accord Electronic stability control Problems

“Purchased june 13, 2020.. Shortly after noticed it's light on dash was on.. I have just become aware what it is, it is still on all the time.. Within a week or two I got an oil change and they suggested I get 2 new tires and a flange on the exhaust would need repaired soon.. A few weeks ago I purchased 2 new tires upon returning home front flashers only began to blink intermittently it continues to do this occasionally.. …”

“Vsa/ tc fail - caused hazard. Problem description: I got stuck on my driveway, on pavement, in a steep section of the road. Tc kept cutting the throttle. Here's what I did: 1) I tried to use the brakes to keep the car from rolling down the hill and to stop the no-traction wheel from spinning. This did not work. Tc kicked in, over and over, causing the car to roll backwards. 2) I tried to use the brakes, during quick foot swap of the pedals (separate application of brake, then gas pedal). This too, did not work. …”

“Vehicle does not accelerate, but hesitates 2-4 seconds from a stop or near stop, then suddenly surges to mid throttle forcing the driver to either brake suddenly or avoid hitting another vehicle. Happened 4 times in one year with my car.”

“The check engine light and vehicle stability assist lights came on first while the car was stationary. The obd codes were scanned and the code p0341 was read. The camshaft position sensor was replaced and the lights turned off and the p0341 codes were cleared. The second time the lights came on the car was in motion. The obd codes were scanned again and the code p1009 was read meaning the vtc actuator is bad and needs to be replaced. This is a very common issue with all 2008-2012 accords and there has been service bulletins issued regarding the problem. …”

“Honda is sending out its cars with the rear wheel camber set to negative 1 to 2 degrees. This causes the tires to wear out on the inside edge and the rear tires do no make proper contact with the road. The front camber is usually set to zero (ie straight up and down for the tires). The smaller contact patch not only wears out the tire edges but makes a safety hazard as the tires wear down and the contact patch decreases. Rotating the tires only makes the problem worse. I requested a wheel alignment at zero miles and again at 6k with the request that the rear tires be set to zero camber. …”