2014 Audi Q5 Technical Service Bulletins

1,388 technical service bulletins (TSBs) are on record for the 2014 Audi Q5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10231133Mar 17, 2014Equipment. Technical bulletins and updates
• 10226436Mar 13, 2014Electrical system. 97 No start (DTC P068A00)
• 10216609Mar 13, 2014Brakes. Updated oil pressure switch
• 10122279Mar 13, 2014Engine cooling. The MIL is on. DTC P164B(00) is stored in the ECM. The oil pressure switch is defective.
• 10122297Mar 11, 2014Engine cooling. Supersedes Technical Service Bulletin Group 80 number 13-05 dated September 11, 2013. Malfunction Indicator Lamp is on. Climate system heating performance is insufficient. Coolant level warning is on. Engine temperature is elevated. "Limp Home" mode is active. Faults are stored in the transmission control module (address word 02). Coolant loss is found from one or more control valves: N82, N509, or N488.
• 10122304Mar 7, 2014Electrical system, Exterior lighting. The high beam is inoperative on one side of the vehicle. The low beams operate correctly. A warning may appear in the instrument cluster. DTCs may be present in the central electrics control module, J519 (address word 09). The connection for the high beam shutter is not connected in the affected headlight.
• 10057287Mar 7, 2014Exterior lighting. Audi : 2013-2016 q5 : the high beam not working on one side of the vehicle. Low beams working properly, the high beam shutter is not connected in the headlights.
• 10228399Mar 6, 2014Fuel system, Engine cooling. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10225078Mar 6, 2014Fuel system. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10222051Mar 6, 2014Fuel system. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10122301Mar 6, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 14-26 dated February 24, 2014. The MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when a phone is connected to the vehicle via Bluetooth when the user searches for a contact name in the MMI address book (by using the MMI control knob or the voice recognition system).
• 10122277Mar 6, 2014Fuel system. The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
• 10226435Mar 4, 2014Equipment. 96 Alarm sounds when driver door is unlocked with mechanical key
• 10122306Mar 4, 2014Equipment, Latches, locks and linkages. The vehicle's anti-theft alarm sounds when the driver door is unlocked with a mechanical key. No DTCs are stored. The keyless remote was not used to unlock the vehicle. In order to minimize current draw after the ignition has been turned off, the electronics system of the vehicle goes into sleep mode. During this time, each module monitors the CAN bus more slowly than when the electronics system is awake.
• 10122300Mar 4, 2014Equipment, Electrical system. The addresses and contacts stored in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus disappear intermittently in vehicles with MMI3G+ Navigation, and in vehicles with or without Audi connect. Intermittently, the MMI system does not appear to remember that the user's myAudi PIN has already been entered, and it requires the user to enter the PIN again in vehicles…
• 10125561Feb 27, 2014Equipment. Supersedes Technical Service Bulletin Group 87 number 12-27 dated April 24, 2012. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor.
• 10231120Feb 24, 2014Equipment. Diagnostics and updates
• 10125564Feb 24, 2014Seats. The MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when the user searches for a contact name in the MMI address book when a phone is connected to the vehicle via Bluetooth. This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact.
• 10125560Feb 24, 2014Electrical system, Engine cooling. Supersedes Technical Service Bulletin Group 85 number 13-17 dated May 15, 2013. DTCs may be stored in the heating and air conditioning electronics control module (address word 08). Improper operation of the fresh air blower could be caused by a faulty printed circuit board in the fresh air blower control module and/or the carbon brushes bind in the brush holder and, as a consequence, lose contact with the motor…
• 10228292Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10224971Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10221944Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10125536Feb 20, 2014Electrical system. Supersedes Technical Service Bulletin Group 00 number 12-34 dated June 6, 2012. The process of draining oil through the drain plug is not always tidy. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10251003Feb 13, 2014Suspension. Rattling or knocking noise from front end when driving over bumps.
• 10125545Feb 13, 2014Equipment. Supersedes Technical Service Bulletin Group 40 number 13-37 dated December 3, 2013. A rattling or knocking noise is heard when the car is driven over bumps or uneven road surfaces. This noise is heard after the car has been driven for a while and is warmed up, and when the temperature outside is warm. This condition can be duplicated if the brakes are applied while the car is being driven over bumpy roads. This…
• 10231118Feb 11, 2014Equipment. Windows XP- End of Support (EOS) and new VAS diagnostic services
• 10054858Feb 11, 2014Brakes. Audi: due to damage abs wheel speed sensor during production, some vehicles may experience steering wheel not locking, ignition key cannot be removed, and other various issues. Model 2009-2014 a4/s4, a5/s5, a5/s5 cab, q5. *pe updated 05/21/2014
• 10250994Feb 6, 2014Engine cooling. Rattling/engine noises in passenger compartment
• 10250662Feb 6, 2014Body and structure, Back-over prevention (rear camera). Rattling/engine noises in passenger compartment
• 10125556Feb 6, 2014Steering. Supersedes Technical Service Bulletin Group 40 number 13-36 dated September 26, 2013. The customer complains that rattling or engine noise can be heard in the passenger compartment. The plastic sleeve of the intermediate steering shaft can slip towards the universal joint (mounting of the power steering rack), causing rattling or engine noise that can be heard in the passenger compartment.
• 10066870Feb 6, 2014Engine. Summary to be provided on a future date.
• 10231117Feb 3, 2014Equipment. Technical bulletins and updates
• 10228393Jan 31, 2014Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10225072Jan 31, 2014Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10222045Jan 31, 2014Electrical system, Engine cooling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10122184Jan 31, 2014Electrical system, Engine. Supersedes Technical Service Bulletin Group 01 number 13-86 dated April 15, 2013. The MIL is on. There is a rough idle. DTCs are stored in the ECM. Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis…
• 10065427Jan 31, 2014Electrical system. Summary to be provided on a future date.
• 10054979Jan 31, 2014Engine. Audi: the engine would have a rough idle, different misfire faults or reduced performance without loss of power or stalling, that causes the malfunction indicator lamp (mil) on. Model 2008-2015 a3, a4, allroad, tt, a5, a5 cabriolet, q5, a6.
• 10228392Jan 24, 2014Fuel system, Engine cooling. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10225071Jan 24, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10222044Jan 24, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10122204Jan 24, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 09-30 dated April 14, 2009. The Audi MMI system will not play audio files from an SD card. The MMI system does not recognize the audio files on the SD card. The MMI system reports that the audio files on the SD card are damaged. The audio files on the SD card will play on one Audi vehicle, but will not play on a different Audi vehicle.
• 10122183Jan 24, 2014Engine. Supersedes Technical Service Bulletin Group 01 number 14-59 dated January 21, 2014. The MIL is on. DTC may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.
• 10065426Jan 24, 2014Engine. Summary to be provided on a future date.
• 10122206Jan 23, 2014Electrical system, Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 13-19 dated May 23, 2013. The light bulb warning light is displayed in the instrument cluster with the ?Vehicle lights: malfunction? message. DTCs are stored in the vehicle electrical system control module. Exterior lights are functioning properly. If the headlight switch is moved to an intermediate position and remains there, the light bulb warning light and…
• 10251028Jan 21, 2014Steering. Alignment - Repair Authorization
• 10228389Jan 21, 2014Fuel system, Engine cooling. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10225068Jan 21, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10222041Jan 21, 2014Fuel system. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No.
• 10122189Jan 21, 2014Wheels, Steering. Supersedes Technical Service Bulletin Group 44 number 13-39 dated July 12, 2013. Vehicle pulls (left or right). Steering wheel is not level or is off-center. These conditions may be noticed during PDI. If the condition is due to outside influence (such as an accident), this TSB does not apply. In an effort to gain information on this condition, Audi of America is asking you to contact the Audi Technical Assistance…

← All problems reported for the 2014 Audi Q5