2006 Chrysler 300C Vehicle speed control Problems

“I was traveling on a highway posted legal speed 65mp as I released the gas pedal it broke and fell on the floor body of the driver side. I then quickly turned on the cruise control to navigate my speed for the nearest safe exit to inspect the damage. Damage was clear that the gas pedal housing unit was broken from the screw ends of the unit, as the housing unit is made of high grade plastic.”

“Depressed accelerator pedal lightly to proceed through an intersection.roughly 10 MPH into the acceleration the vehicle suddenly without warning accelerated on its own through the next intersection causing a 3 car accident and 4 people injured.all vehicles involved were disabling damage with mine being the worst, total loss.air bags did not deploy causing injury to passenger and I resulting in seizures to passenger from head trauma.this defect of the vehicle has caused a major financial burden on me and my family from the date of accident and well into the future with my insurance rates…”

“I was on the way to a doctors appt with my pregnant daughter on 264 heading towards chesapeake, va. I was doing 55 MPH and the tank was on 1/8 th of a tank. As we were driving, about 15 min later, the car lurched, a ding was heard, the etc light flashed, the rpms dropped to 0, then resumed a second later causing the lurching forward. About 3 to 4 minutes and intermittently over the next 15 min later, it did the same thing, but also stalled at the stop lights on the way there. No codes came up when diagnostics were put on it. …”

“I filled up the car with gas and after driving about half a mile the engine stalled while in traffic. The car started and stalled repeatedly five or six times for about four blocks. At a certain point the problem stopped and the car was drivable. I took the car to a nearby auto shop and they found no error codes in the system. After leaving the auto shop the car continued to drive without stalling. Several weeks later I filled up with gas again and the problem repeated itself after driving about half a mile. The engine stalled about five times. …”

“My Chrysler 300C hemi started idling rough and showing code p0300. Oil/plugs were changed, and my car worked well for ~500 miles. After which the low oil level light chimmed. After taking to the dealer the oil pressure switch was replaced and all was right. Close to a month later, while stopped at a rail crossing the car stalled with error code p1520. I checked the oil which was low and added to the correct level. In the oil, there was no discoloration or anything to cause alarm. I started the engine up and while the p1520 was gone I had the p0300. …”