2007 Ford Five Hundred Steering Problems
- Complaints
- 6about this part
- Share
- 3%of 199 total for the year
- Median mileage
- 63,500miles
- Trend
- Not enough dataFewer than 15 complaints, too few for a reliable trend.
NHTSA recorded 6 complaints about the steering of the 2007 Ford Five Hundred, 3% of the 199 complaints for this model year. Where a mileage was given, the median is 63,500 miles.
Fewer than 15 complaints name this part, so treat the figures as a rough indication only.
Example complaints
Selected from NHTSA records; personal details are removed. They are consumer reports, not findings.
“While driving down the street at midnight the car warning lights started to come on (ABS, battery, traction control, and finally the factory stereo/GPS unit) one by one. Then followed by the dashboard illumination going out which means I now had no taillights. Then finally lost all acceleration and the car just stopped. Luckily, I was able to illegally park the car blocking a driveway and fire hydrant. Had I been on the highway I may have had a completely different ending. …”
NHTSA complaint #10641434, filed 2014-10, 95,455 miles“I recently ran into a major issue with my 2007 Ford Five Hundred which really scared me. I was rotating the tires on the car and when I was removing the wheel from the drivers side of the car I noticed that the wheel wobbled back and forth. At first I thought this was just a bad ball joint and purchased a new one to replace it. When I started to remove the factory installed ball joint I noticed that the nut that holds the ball joint to the lower connection joint was on the verge of coming off. …”
NHTSA complaint #10631252, filed 2014-09, 74,000 miles“My Ford began acting strangely when turning, and would hydroplane badly when raining. I took it to my independent garage and they found that the left lower ball joint retaining nut had worked loose. That caused the left front wheel to move in toward the ball joint and the joint or nut tore the tire down to the steel belt. The service manager indicated that it appeared that the nut was not torqued correctly at the factory. Of course, I had to have the ball joint replaced and two new tires. I did notify Ford motor co.”
NHTSA complaint #10434439, filed 2011-11, 53,000 miles“Car has developed a noise in front end. A knocking when turning wheel at slow speeds. The Ford dealer has put new struts, bearing plates and link pins on car. Still has noise. I drove a new one sat and it did not do this. The dealer talked to Ford about this and was told release the vehicle as normal and characteristic of design if noise is the same and also minimal if a new one does not make this noise, why does mine? My wife is concerned something is going to happen to the steering.”
NHTSA complaint #10231278, filed 2008-06, 5,000 miles“The contact owns a 2007 Ford Five Hundred. The contact stated that while driving approximately 20 MPH, the steering began pulling to the right accompanied by an abnormal clunking noise. The vehicle was taken to the dealer for diagnosis where the technician stated that the rack and pinion would need to be replaced. Approximately 28,000 miles after the rack and pinion was replaced, the failure recurred. The manufacturer was made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 28,100.”
NHTSA complaint #10559060, filed 2014-01, 28,100 milesSteering: other model years
Other parts of the 2007 Ford Five Hundred
70 complaintsTransmission and drivetrain
59 complaintsFuel system
35 complaintsElectrical system
22 complaintsEngine
21 complaintsEngine cooling
19 complaintsOther or unknown
8 complaintsBody and structure
8 complaintsEquipment
7 complaintsAir bags
6 complaintsSuspension
4 complaintsTires
4 complaints
← All problems reported for the 2007 Ford Five Hundred
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 29, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.
To check a specific vehicle for open recalls, use its VIN at nhtsa.gov/recalls. Methodology