2018 Ford Fusion Back-over prevention (rear camera) Problems

“The audio/navigation display screen on my 2018 Ford Fusion went black as I was backing out of a parking spot almost causing an accident. It immediately came back on after this but unfortunately, it started to happen regularly upon startup, while driving, parked, just randomly, and for longer periods of time. It also started to increase the volume and I couldn't control it. The system completely stopped working after several weeks. I did a lot of research and noticed that this is a significant problem with Ford Accessory Protocol Interface Modules (APIM). …”

“The contact owns a 2018 Ford Fusion. The contact stated that while reversing, the back-over prevention camera displayed a black screen. Several minutes later, the message Contact the Dealer was displayed. The vehicle was taken to the dealer to be diagnosed, and the contact was informed that the VIN was not under recall. The dealer had not diagnosed or repaired the vehicle. The dealer referred the contact to the NHTSA Hotline to report the failure. The manufacturer was not notified of the failure. The failure mileage was approximately 88,000.”

“The contact owns a 2018 Ford Fusion. The contact stated that the center digital screen failed to illuminate, and the screen was black while the vehicle was shifted into gear. No warning light was illuminated. The local dealer was contacted. The vehicle was not diagnosed or repaired due to the VIN not being under recall. Upon further investigation, the contact related the failure to NHTSA Campaign: 25V695000 (Back Over Prevention); however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 117,000.”

“The contact owns a 2018 Ford Fusion. The contact stated while reversing, the back-over prevention camera went blank. The contact shifted into the drive and the screen started rebooting independently. The contact stated that after turning off and restarting the vehicle, the instrument panel started flashing with the radio inoperable message displayed. The vehicle was diagnosed, and the contact was informed that the back-over prevention camera was not activated. The contact checked the fuse, and the fuse was properly secured. …”

“The contact owns a 2018 Ford Fusion. The contact stated that while driving the infotainment touch screen went black with no warning. The contact stated that the rearview camera and hands-free feature were inoperable. The vehicle was taken to a dealer where the failure was diagnosed with a failed Accessory Protocol Interface Module (APIM). The contact stated the APIM was not communicating with the vehicle. The APIM needed to be replaced. The contact stated that the vehicle was not been repaired due to the cost. …”