2024 Toyota Corolla Lane departure Problems

“My vehicle will jerk into the left lane of the road when lane keeping assistance is activated. It appears isolated only to situations when I am travelling on roads that were recently repaved and lines haven't been painted yet. However, these roads are equipped with consistent reflective indicators marking the center of the road because these roads remain unpainted for months. There are many of these roads where I live so it is a frequent issue that I experience multiple times everyday. …”

“On 11/29/23 after 11:30pm, I was in the process of clearing an exit and at the tail end of the exit it felt like the car was correcting itself and I was unable to stay turning right. The steering wheel felt locked and I was unable to control the car. The car impacted the guardrail and I was able to regain control after the initial impact. -This is a BRAND NEW car with less than 100 miles at the time of the accident. - Prior to the collision, there were no warning signals from the dashboard. …”

“My daughter was on the interstate using cruise control; wet roads but no heavy rain or puddling. The LTA pulled her car off the road, She had to fight to get control of the car to prevent hitting the middle concrete barrier. Once she got the car back into the lane, it jerked the other way down a gravel embankment resulting in scratches and damage to the undercarriage shield. Toyota said the LTA was functioning properly when they tested it in their repair center but also advised to turn that technology off if it was malfunctioning. …”

“Ever since my vehicle was new, the driver side blind spot monitor will periodically not work. This issue occurs primarily when starting the vehicle using the Toyota app, but also will have the issue when starting the vehicle normally. When all conditions are met, the driver side blind spot monitor will fail to illuminate during an entire trip unless the driver either: turns the vehicle off and back on, or: goes into the vehicle settings while driving and turns the blind spot monitor off and then on again. …”