2010 Nissan Murano Engine cooling Problems
- Complaints
- 2about this part
- Share
- 1%of 193 total for the year
- Median mileage
- 85,500miles
- Trend
- Not enough dataFewer than 15 complaints, too few for a reliable trend.
NHTSA recorded 2 complaints about the engine cooling of the 2010 Nissan Murano, 1% of the 193 complaints for this model year. Where a mileage was given, the median is 85,500 miles.
Fewer than 15 complaints name this part, so treat the figures as a rough indication only.
Example complaints
Selected from NHTSA records; personal details are removed. They are consumer reports, not findings.
“The contact owns a 2010 Nissan Murano. The contact stated while driving at various speeds, the transmission was slipping in and out of gear. The check engine warning light was illuminated. The vehicle was taken to a local Pep Boys where it was diagnosed that the catalytic converter had failed, the camshaft position sensor, and the power train system also had failed. The dealer and the manufacturer were not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 171,000.”
NHTSA complaint #11494756, filed 2022-11, 171,000 miles“The contact owns a 2010 Nissan Murano. The contact stated that there were unusual fumes being emitted into the vehicle. The vehicle was taken to an authorized dealer, who stated that there was a leak within the head gasket. As a result, the head gasket and transfer case needed to be replaced. The remedy did not repair the failure. The manufacturer was made aware of the failure, and offered to make the additional repairs at no cost. The manufacturer also offered to extend the warranty on the parts that were being replaced. The vehicle was not repaired. …”
NHTSA complaint #10409066, filed 2011-06, 1 milesRelated service bulletins
- 10208946Feb 22, 2022CAN COMMUNICATION â NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10208953Feb 7, 2022DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this…
- 10153007Jan 29, 2019NISSAN; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin does NOT apply to LEAF vehicles and Titan XD vehicles with V8 diesel engine. This bulletin has…
- 10192591Jun 24, 2015SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as…
- 10192293Jan 13, 2014SERVICE INFORMATION Replacement Engine Control Modules (ECMs) for many newer Nissan vehicles are now "Blank" ECMs. Blank ECMs come without software and must be programmed (not…
- 10037980Feb 25, 2011Nissan: there is a fluid leak from the transfer assembly. 2009-2011 murano.
- 10035664Jan 19, 2011Nissan: cold start control. Confirm bulletin applies and if applies reprogram the ecm.
Engine cooling: other model years
| Year | Complaints | Share of year |
|---|---|---|
| 2016 | 4 | 4% |
| 2015 | 2 | 1% |
| 2014 | 1 | 1% |
| 2013 | 2 | 3% |
| 2012 | 1 | 1% |
| 2010 | 2 | 1% |
| 2009 | 7 | 1% |
| 2007 | 10 | 1% |
| 2006 | 11 | 1% |
| 2005 | 24 | 2% |
| 2004 | 38 | 6% |
| 2003 | 98 | 12% |
Other parts of the 2010 Nissan Murano
56 complaintsTransmission and drivetrain
40 complaintsElectrical system
22 complaintsOther or unknown
18 complaintsBody and structure
16 complaintsSuspension
15 complaintsAir bags
13 complaintsVisibility (wipers, defrost, mirrors)
9 complaintsEngine
8 complaintsSteering
6 complaintsSeats
4 complaintsWheels
4 complaints
← All problems reported for the 2010 Nissan Murano
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 28, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.
To check a specific vehicle for open recalls, use its VIN at nhtsa.gov/recalls. Methodology