2018 Toyota Camry Lane departure Problems

“Many times the blind spot monitor doesn't work properly. When there is no vehicle nearby and driving alone on the road, still the blind spot monitor light up and notify of vehicle at my blind spot and sometime when there is a vehicle at my blind spot overtaking the it shows when the vehicle has already passed. While driving on cruise control suddenly it says cruise control not available. This doesn't happen always but sometime. Both of the above happened while driving on highway.”

“If you slow to a roll then try to accelerate, it jerks real bad like it does not know what gear to go into. Tapping from the engine bay that comes and goes. The brake assist feature cause my rotors to get warped right after replacing them. Lane keeping assist will yank you over into a turning lane if you aren't super careful.”

“There are multiple warning lights on my dash at this time. The following malfunctions are showing on my dash at this time: Pre-Collision System Malfunction, LDA Malfunction, Headlamp malfunction, SRS Malfunction, Low Braking Power, Secondary Collision Brake System Malfunction, Power Steering Malfunction, Antilock Brake System Malfunction. These started coming on around two weeks ago. I have no blinkers available and my steering stiffens to where the car is almost undriveable. …”

“I was driving my daughter to work then all of a sudden 6 different vehicle alerts came on my dashboard. Vehicle Alerts: advanced ultrasonic detecting and ranging system, lane departure alert, pre-collision system, parking brake system, vehicle stability control system, and secondary collision brake system. I was at a stop light then the car would not drive it was like it started stalling. I had to put on my hazard lights then turn the car off and back on. That's when I was able to accelerate to 20 mph to get out of traffic. I could not give to car any gas to move. …”

“While operating my vehicle, the multi information display between the tachometer and RPM gauges flashed bold red letters BRAKE (even though nothing was in front of us at all) then the screen went 100% black. When that happens, the majority of the safety features are obsolete because you cannot see or read what caused the beep. …”